International Research Journal of Engineering and Technology (IRJET) Volume: 04 Issue: 03 | Mar -2017
www.irjet.net
e-ISSN: 2395 -0056 p-ISSN: 2395-0072
AUTOMATED DRIVING TEST AND ISSUING OF DRIVING LICENSES Apurva Meshram1, Kewal Jadhav2, Rani Jibhekar3, Mrs. Kavita Katole4 Dr. Babasaheb Ambedkar Colleage of Engineering & Research, Nagpur, Maharashtra India. Department of Electronics Engineering ---------------------------------------------------------------------***--------------------------------------------------------------------
Abstract -To prevent accident due to under age children
The sensors used are gyro sensor to define coordinates in terms of longitude and latitude of a test vehicle .While rpm sensor is used to sense and measure speed at every angle of test vehicle .wireless sensor network includes global positioning system.(GPS). GPS provide data for mapping, receives X,Y, Z co-ordinates according to position of a vehicle. The software required for proposed work is .NET for visual data while Ms-access for back end application.
to avoid the making of illegal license as new automation system proposed. The purpose and propose of the system that need to be design a sensor which is wireless which work on the basis of detection of result. The system help us to eliminate and to improve the Indian driving license authority so that the people making the falls license will be stop. The license will be issued to an applicant depending upon skill of driving by use of the number of sensor which are connected to embedded system the system will compare with the given parameter given by the driving license authority. Key words: WSN, GPS, Map Matching, Gyro sensor, RPM sensor
3. HARDWARE DESIGN The system hardware includes: Microcontroller (AT89C51), Serial Communication IC (MAX232), 8 bit ADC (0809), GPS Receiver, Gyro Sensor RPM sensor.
1. INTRODUCTION A driving license is an official document certifying that the holder is able to drive a motor vehicle. Most of the person is dying on road accident in every 30 seconds because of ineligible drivers with illegal license. So it is very important to disassociate the driving ability test from the licensing authority. In this process the applicant will be allotted the test vehicle for test drive with the two sensors connected to system in vehicle sending data using wireless sensor network to remote server to processed. We are giving a figure of ( 8 ) depending upon each point the angel and speed is varying. Result analysis is done by comparing the received data with previous data. If the parameter match up to a certain end near about 80% the license will be issue if not it will be rejected
Fig -1: Hardware Design Microcontroller (AT89C51) The AT89C51 is a low-power, high-performance CMOS 8-bit microcomputer with 4 Kbytes of Flash Programmable and Erasable Read Only Memory (PEROM). The device is manufactured using Atmel’s high density nonvolatile memory technology and is compatible with the industry standard MCS-51Ô instruction set and pin out. The on-chip Flash allows the program memory to be reprogrammed in-system or by a conventional nonvolatile memory programmer. By combining a versatile 8-bit CPU with Flash on a monolithic chip, the Atmel AT89C51 is a powerful microcomputer which provides a highly flexible and cost effective solution to many embedded control applications.
2. PROPOSED WORK The proposed work consist of hardware and software design implementation to issue driving license. Provide license to applicant by no. of steps as follows1) The applicant will be allotted the test vehicle for test drive. 2) Two sensors are connected to embedded system in vehicle sending data using wireless sensor network to remote server to get processed. 3) Result analysis is done by comparing the received data with previous data.
© 2017, IRJET
|
Impact Factor value: 5.181
|
ISO 9001:2008 Certified Journal
|
Page 847