International Research Journal of Engineering and Technology (IRJET)
e-ISSN: 2395 -0056
Volume: 04 Issue: 03 | Mar -2017
p-ISSN: 2395-0072
www.irjet.net
SMART REAL TIME PATIENT RECEPTION MANAGEMENT SYSTEM Prof.Ms.S.S.Tamboli1, Ms. Priyanka Patil2, Ms. Deepali Patil3, Ms. Kavita Patil4 , Ms. Priyanka Desai5 1Assistant
Professor, Department of Electronics And Telecommunication of Annasaheb Dange College of Engineering and Technology, Ashta, Maharashtra, India 2,3,4 Student , Department of Electronics and Telecommunication of Annasaheb Dange College of Engineering and Technology, Ashta, Maharashtra, India
---------------------------------------------------------------------***--------------------------------------------------------------------system. In this system user have to take appointment from Abstract - This paper describes a design and implementation of advanced patient reception management system using telecommunication system. The goal of this system is to improve the time management by using information and technology to improve the efficiency of service. The visionary of healthcare industry is to provide better healthcare to people anytime and anywhere in the world in a more economic and patient friendly manner. Therefore for increasing the patient care efficiency, there arises a need to improve the patient reception management system and make them more mobile.
the same place where he present through the SMS. According to this system server sends return feedback to the user about appointment timing. When user can sends the SMS to hospital at closing time, then he get message about no appointment at present day on mobile phone. The information about user can verified by server and this information sends to the 8051 microcontroller for display case no. on LED board.
Key Words: Smart Phone, Global system monitoring (GSM), Short messaging system, MAX 232, 8051 Microcontroller.
The 230 volt AC supply is given to the step down transformer because 8051 microcontroller support to 5 volt only. After that AC voltage is controlled into DC voltage by using rectifier. Then fixed DC voltage is regulated by using voltage regulated. Here we get fixed 5 volt DC supply. This DC supply is given to the LED display, 8051 microcontroller and MAX 232 IC. MAX 232 output is not directly is not directly connected to GSM modem hence, here we are using DB9 connector between 8051 microcontroller and MAX 232. GSM module is used for transmitting and receiving data message and it is connected to server.
1. INTRODUCTION In traditional hospital reception management system, the patient takes Dr. appointment in hospital itself. This process is time consuming and we get so many efforts while taking appointment. So, to overcome problem of patient reception management system we are going to implement GSM based Smart real time patient reception management system.
3. BLOCK DIAGRAM
Mobile
2. RESEARCH METHODOLOGY
8051 Microcontroller
2.1 Problem Identified
GSM Module
Server
LED Display
The main problem caused in case of reception is that it was required manual process for appointments. The hospital cannot take any responsibility for their solution. But patients are facing lot of problems due to this manual process. In this process data is randomly collected and sends to OPD, then called one by one patients. Due to this process sometimes patient may suffers from the problem of wastage of time. Another issue is that he didn’t get appointment on that day.
Microcontroller Interfacing Power supply
8051
LED Display
Microcontroller Reset Input switches
2.2 Proposed Work
Crystal Osc.
To overcome this problem of traditional reception system we are going to implement patient reception management Š 2017, IRJET
|
Impact Factor value: 5.181
|
ISO 9001:2008 Certified Journal
|
Page 647