International Research Journal of Engineering and Technology (IRJET)
e-ISSN: 2395 -0056
Volume: 04 Issue: 02 | Feb -2017
p-ISSN: 2395-0072
www.irjet.net
A review on Design and Fabrication of Frumentum Maskin Shailesh Dharpure1,Tushar Kumbhalkar2,Yadnesh Dhabre3,Mahesh Kanojiya4 1 Student,
Mechanical Engineering Department, Nagpur Institute of Technology, Nagpur, Maharashtra, India. Mechanical Engineering Department, Nagpur Institute of Technology, Nagpur, Maharashtra, India. 3 Student, Mechanical Engineering Department, Nagpur Institute of Technology, Nagpur, Maharashtra, India. 4 Professor, Mechanical Engineering Department, Nagpur Institute of Technology, Nagpur, Maharashtra, India. 2 Student,
---------------------------------------------------------------------***--------------------------------------------------------------------2. PARTS
Abstract - This paper describes about the new idea that
deals with the grain shops, ration shops, etc. This helps in reduction of wastage of grains by supplying grains to customers. This project consists following components they are hopper, lead screw and sliding mechanism. This assembly is connected with automated mechanism with solenoid valve as a sliding mechanism which control flow of grains.
Frumentum Maskin consists of following components, 2.1 Base 2.2 Lead screw 2.3 Hopper
Key Words: microcontroller, solenoid
2.4 Electronic Devices
valve,pneumatic cylinder.
2.5 Mechanism
1.INTRODUCTION A Frumentum Maskin is a machine which is used to provide frumentum (grain) to the customers without wastage of frumentum (grain) on ground or floor. The name “Frumentum” is a Latin word means grain; and “maskin” is a Swedish word means machine.In grain shops and government contols, it seen that most of the grains get wasted by falling on A Frumentum Maskin is a machine which is used to provide frumentum (grain) to the customers without wastage of frumentum (grain) on ground or floor. The name “Frumentum” is a Latin word means grain; and “maskin” is a Swedish word means machine . In grain shops and government contols, it seen that most of the grains get wasted by falling on ground or floors during providing frumentum to the consumers and these are of no use. By seeing that, the concept of the frumentum maskin is introduced
2.1 Base Base is the most important part of the machine and it placed at the bottom of the machine. All the load of maskin acts on the base. Load cell is attached to the base so as to measure the weight of the grains.
2.2 Lead Screw Lead Screw is used to provide to perform linear motion to the hopper to slide it up and down. The functions of the lead screw are to support the hopper and to provide motion to it and also to adjust the height of hopper. The hopper comes down and gets filled by frumentum and then moves up with the help of lead screw which is connected to motor via. Chain and sprocket. Lead screws used are two in numbers.
Frumentum will place in hopper and extracted out with the help of hose pipe as the sliding plate moves. The time is set
2.3 Hopper
for the sliding plate to move the plate with the help of sliding
Hopper is a hollow transition piece going from larger to
mechanism which is controlled by controller.
smaller size, also known as a reducer. The grains are stored in hopper with hopper the frumentum flows in a proper way as from hopper to the bags or containers
© 2017, IRJET
|
Impact Factor value: 5.181
|
ISO 9001:2008 Certified Journal
|
Page 2010