11mm Laminate faced wall panel Collections
Installation Guide
Pre-installation Check-list
Checked
1 Some panels are supplied with clear protective polycoating to the face, and white laminate to the rear. The clear polycoating should be carefully peeled back to inspect the surface, and replaced for installation. This is particularly important where polycoating has text over-printed.
Remove Protective Film
2 Inspect wall panels & profiles for any flaws, defects or damage. 3 Check colour, sheen level and pattern concentration consistency between all panels and profiles. 4 If panels are being fitted by a tradesman, colours should be approved by end user. 5 Please ensure to read this guide in full before commencing installation. Once installation has commenced the panels are deemed to have arrived in perfect condition, any of the above reported after installation will not be covered by your warranty.
Conditioning & Storage
Recommended Tools • Ruler • Pencil • Masking tape • Measuring tape • Silicone sealant & silicone gun • Power drill & screwdriver • High-grab adhesive • Jig saw, hand saw or circular saw
Larger panels should always be carried by two people
Panels should not be stored in areas of high humidity
Do not store outside or lean at an angle against a wall
Store flat and horizontal to prevent bowing
Store in cool dry conditions between 5-25°C
Condition panels & adhesive at room temp. for 48-72 hours
IG 013 Rev1
1
Issued: 08/05/2025