JAMES HARDIE
FASTENER GUIDE
CHOOSE THE RIGHT FASTENER AND NAILER FOR THE TASK! Type of fastener
ZE
PC
GRF
HA-35
PC-50
TF-16
VF-16
AB-15
PE-30
PF-50
PZ
PQZ
HardiePlank® Facade 839052 TJEP PC 28/48 ring nails, 15º, HDG
839479 TJEP PC 28/48 ring nails, 15º, stainless A4
833050 TJEP GF 28/50 ring nails, 34º, Handybox, HDG
834850 TJEP GR 28/50 ring nails, 34º, Jumbobox, HDG
834050 TJEP GR 28/50 ring nails, 34º, Maxibox, HDG
833364 TJEP GF 31/63 ring nails, 34º, Handybox, stainless A4
Hardie® VL Plank 839809 TJEP PC 25/35 ring nails, 15º, Haften, stainless A2
839812 TJEP HA 28/32 ring nails, 22º, Haften, stainless A2
Hardie® Trim™ 842151 TJEP TF-16 finish nails 50 mm, 0º, stainless A4
842452 TJEP VF-16 finish nails 51 mm, 20º, rostfri A4
842551 TJEP AB-15 finish nails 50 mm, with glue, 34º, stainless A4
James Hardie® EPDM Tape 841111 TJEP PE-30 staples 10 mm, stainless A2
841211 TJEP PF-50 staples 10 mm, stainless A2
Hardie Shield™ 835051 TJEP ZE 25/50 ring nails, 0º, HDG
835450 TJEP ZE 25/50 ring nails, 0º, stainless A2
835351 TJEP ZE 25/50 ring nails, 0º, stainless A4
839051 TJEP PC 25/50 ring nails, 15º, HDG
839451 TJEP PC 25/51 ring nails, 15º, stainless A2
836050 TJEP CN 25/50 ring nails, 15º, HDG
840238 TJEP PZ-16 staples 38 mm, with glue 1)
1) Only used if there is no requirement for K1 10 B-s1, d0- (class 1) casing Max KPa wind load - see James Hardie® installation instructions. All above nails are approved for l K110 solution - see James Hardie installation instructions. We reserve the right to make changes and typographical errors. Additional installation information is available at www.jameshardie.com. Information about the nailer can be found at the following address: www.tjep.eu. © KYOCERA UNIMERCO 02.24 016_3300
James Hardie Building Products Ltd. 7 The Priory Old London Road Canwell Tlf. 0121 311 3480
Page 1 of 2
KYOCERA UNIMERCO Fastening A/S Drejervej 2 · DK-7451 Sunds Tlf. 97 14 14 40 · Fax 97 14 14 86 tjep@kyocera-unimerco.com