HANGER BOLT/LAG SCREW Stainless Steel T316 Dual threaded stud-wood screw thread and metric machine threaded with an internal hex drive. Used for permanent or removable connections in many applications like balustrading. Can be used with a wide range of nuts (not supplied)
CLEARANCE HOLE MINIMUM (MM)
METRIC TIMBER THREAD THREAD LENGTH (MM) LENGTH (MM)
SIZE (MM)
MSL CODE
PILOT HOLE* (MM)
M8X80
HANGXM880T
5-6
9
34
45
M8X100
HANGXM8100T
5-6
9
38
58
M10X80
HANGXM1080T
7-8
11
32
47
M10X100
HANGXM10100T
7-8
11
40
60
M10X120
HANGXM10120T
7-8
11
45
74
M10X140
HANGXM10140T
7-8
11
55
84
*Pilot hole may vary depending on the softness/hardness of the timber
Installation Drill a pilot hole into the timber substrate Using a hex driver bit screw the hanger bolt into the timber substrate until the desired height is achieved.
0800 425 262 steelandtube.co.nz Disclaimer: this data should be used as a guide only, for exact applications you should engage the services of a qualified engineer.
APR 2024
SPECIFICATION SHEET
Lower material to be fixed over the top of the hanger bolt, then tighten with the nut of your choice.