k
ACCESSORIES Bigger plans? Visit abstracta.com to scale and personalize your CubitzKitz by adding extra parts and accessories.
®
THE STARTER KIT - PARTS LIST
Tubes
BUILD KIT (49) Aluminum Tubes • Polymer Connectors (0) 2T • (16) 3T • (12) 4T • (4) 5T • (2) 6T (2) Acrylic Shelves DESIGN KIT (49) 1/2-Scale Plastic Straws • (26) 1/2-Scale Plastic Connectors Isometric Graph Paper
15" Tube
TOOLS (1) Hammer • (1) Disconnect Tool • (1) Safety Glasses
Feet
Imagine
Design
Every foot and caster must be connected to the structure using a 3" leg.
Slider Foot
Adjustable Foot
Caster
Surfaces
3" Leg
Use recommended configurations in this instruction booklet...
...or sketch unique concepts on included Isometric graph paper.
Prototype in half-scale using the orange Straw-and-Connector Kit. Make changes as needed.
Create Surface Slats
Connectors
Acrylic Shelf
Disassemble
2T
3T
4T
5T
IMPORTANT! - Do NOT flex tubes. Flexing tubes into place can snap connectors.
6T
Tools
4
Dead Blow Hammer
Repeat Process to build intended design.
3
Disconnect Tool
1
Make “Bones” by inserting proper connectors into tube ends. Hammer flush. Rotate connectors until symetrical.
2
Always assemble using BLUR method - Bones, Ladders, Upright Tubes, Repeat.
Consort Corporate Office: 2129 Portage Street Kalamazoo, MI 49001 (800) 525.6424 (269) 388.4532 • Fax: (888) 880.6341
www.abstracta.com info@consort.com
IMPORTANT! Do NOT sit or stand on CubitzKitz structures.
Connect “Ladders” using upright tubes.
Make “Ladders” by connecting bones using intermittent tubes.
Firmly grasp tube and slide disconnect tool, striking connector along multiple arms, evenly distributing pressure. Point tube down so the connector will not hit anything when disconnected.
Using hammer to disassemble can lead to broken connectors.
IMPORTANT! Use safety glasses to assemble/disassemble.