INSTALLATION INSTRUCTIONS WALL MIXER USING FOR:
2
Noggin
1. The centre Distance of the mixer body is 120mm.
120 mm
52mm-72mm
2.Creat two suitable holes in the cement sheet and tiles 3. Finish the tiles, to maintain the length at 11mm to 13mm (from the tile to the end of the thread pipe). If exceed 13mm, Please cut the rest. To wrap the tape round the thread pipe and tight the spout connector with the thread pipe.
Cement sheet and Tiles Spout Connector
Dress plate
Thread Pipe
1. Screw the Mixer Body onto Noggin
4. Remove the protective cover, Push the Dress Plate onto the body Noggin
3. Connect Hot and Cold Water Supply 4. Test and Check for Leaks
Cold
1
Dress plate
11mm to 13mm
2. Ensure the Mixer Body is level
Cement sheet and Tiles
Hot
1. Push Wall Outlet to the spout adaptor and fasten Grub Screws to secure Wall Outlet
Grub Screw
2. Fit Mixer Handle into position and tighten Grub Screw to secure handle
Grub Screw Wall outlet Cap
3
3. Fit Cap into Position
Recommended
Note:
MAINTENANCE AND CARE:
Working Pressure
1. If the pressure exceeds or likely to exceeds 550kpa,
1. Products Should be cleaned with mild liquid
150-500kpa
an approved pressure limiting device must be installed.
detergent or soap and water
Maximum Hot
2. Flush Out all pipe work prior to installation.
2. Do not use cream cleaners or citrus based
Water Temperature
3. If the water temperature exceeds 75℃, an approved
cleaning products, as they are abrasive.
75 degrees
tempering valve must be fitted.
3. Use of unsuitable cleaning agents may
4. Installation should comply with Australian Standard AS3500.
damage the surface. any damage caused in
Failure to comply with the above may void all warranties.
this way will not be covered by warranty
Disclaimer While we aim to ensure the specifications shown are correct at the time of printing, Attica Australia reserves the right to make modifications without prior notice.