INSTALLATION INSTRUCTIONS BASIN MIXER USING FOR:
1. Cut a mounting hole 35mm in dismeter 2. Fit Rubber Ring into groove on the mixer base 3. Fit Hoses through the mounting hole and place the mixer over the mounting hole 4. Fit Rubber Gasket and Metal Disc over Threaded Tail and screw on lock nut to secure the mixer 5. Connect Red Hose to hot water supply and blue hose to cold water supply O-Ring
6. Turn on water supply and check for leaks
Threaded Tail Rubber Gasket Metal Disc Lock Nut
Red/Blue Hose
Recommended
Note:
MAINTENANCE AND CARE:
Working Pressure
1. If the pressure exceeds or likely to exceeds 550kpa,
1. Products Should be cleaned with mild liquid
150-500kpa
an approved pressure limiting device must be installed.
detergent or soap and water
Maximum Hot
2. Flush Out all pipe work prior to installation.
2. Do not use cream cleaners or citrus based
Water Temperature
3. If the water temperature exceeds 75℃, an approved
cleaning products, as they are abrasive.
75 degrees
tempering valve must be fitted.
3. Use of unsuitable cleaning agents may
4. Installation should comply with Australian Standard AS3500.
damage the surface. any damage caused in
Failure to comply with the above may void all warranties.
this way will not be covered by warranty
Disclaimer While we aim to ensure the specifications shown are correct at the time of printing, Attica Australia reserves the right to make modifications without prior notice.