INSTALLATION INSTRUCTIONS DIVERTER MIXER WITH DIVERTER USING FOR: Noggin
Dress plate
1.Creat two suitable holes in cement sheet and tiles 2.Remove the protective cover, push the Dress Plate onto the body
68mm
3.Push on the handle and Diverter Cup then Fasten the Grub Screw 4.Fit Cap into position
2
Cement sheet and Tiles Diverter
Outlet1
Dress Plate
1. Mount the Mixer Body in Place Using the screws
Diverter Cup Grub Screw Cap
2. Ensure the Mixer Body is level 3. Connect water supply and water outlet, test and check for leaks Hot Inlet
Cold Inlet
Mixer Body
Handle
Grub Screw Cap
1
3
Outlet2 Recommended
Note:
MAINTENANCE AND CARE:
Working Pressure
1. If the pressure exceeds or likely to exceeds 550kpa,
1. Products Should be cleaned with mild liquid
150-500kpa
an approved pressure limiting device must be installed.
detergent or soap and water
Maximum Hot
2. Flush Out all pipe work prior to installation.
2. Do not use cream cleaners or citrus based
Water Temperature
3. If the water temperature exceeds 75℃, an approved
cleaning products, as they are abrasive.
75 degrees
tempering valve must be fitted.
3. Use of unsuitable cleaning agents may
4. Installation should comply with Australian Standard AS3500.
damage the surface. any damage caused in
Failure to comply with the above may void all warranties.
this way will not be covered by warranty
Disclaimer While we aim to ensure the specifications shown are correct at the time of printing, Attica Australia reserves the right to make modifications without prior notice.