PORTLAND IP54 LED BULKHEAD INSTRUCTIONS Issue 04 25th May 2022 THANK YOU for purchasing this product. To ensure it provides complete satisfaction, please install it in accordance with these instructions and then pass the instructions to the appropriate person for retention and future reference. SAFETY This is a mains voltage powered luminaire. It is designed to be installed by suitably qualified personnel only and in accordance with the applicable building and electrical regulations. Before installation or maintenance, the electrical supply to the luminaire must be isolated. INSTALLATION SUPPORT For installation support or accessories, please contact us at the above address. When reporting a suspected fault or seeking installation support, the problem is likely to be resolved most quickly if you have full product details to-hand, as well as details of when and where it was purchased. INSTALLATION
1. 2. 3. 4.
5. 6. 7. 8. 9.
Remove the diffuser from the base by turning anti-clockwise. Loosen the 3 geartray retaining screws and rotate anti-clockwise to align the screw heads with the large aperture of the keyhole slots & remove the geartray from the base. Prepare the mains supply cable & fixing points on the chosen mounting surface, ensuring it is able to retain the weight of the luminaire. Pass the mains supply cable through the cable entry hole, offer the base to the mounting surface & secure using the screws provided. Note! It is the installer’s responsibility to ensure the fixing points & cable entry point are appropriately sealed to maintain the IP rating Route the mains supply cable to the terminal block on the gear tray & terminate ensuring correct polarity is observed. Note: This is a class I luminaire and must include a protective earth. Refit the gear tray (reverse of point 2) & secure by retightening the geartray retaining screws. If the CCT Selectable option has been chosen, then select the required CCT by sliding the switch on the front face of the gear tray to the allocated colour (Note: Please ensure the luminaire is switched off when selecting the colour temperature). Refit the diffuser by locating the slots with the lugs in the base & then rotating clockwise. Reconnect power supply & check for correct operation. Do not insulation test. For maintained emergency and microwave versions, please refer to the additional instructions below.
1