KANSAS LIFE INSTRUCTIONS Issue 03 April 2026 STANDARD VERSION P1-P2 SELF TEST VERSION P2-P3 BLACK VERSIONS P3-P4 DAM3 VERSIONS P5-P6 Thank you for your purchase For best results, have this light fitting installed by a qualified electrician, following these instructions. Keep this leaflet for future reference. Safety
• •
Mains powered – installation must comply with building and electrical regulations. Always switch off and isolate the power before installation or maintenance.
Need Help? For advice or accessories, contact us at the address above. Please have the product name, model, and purchase details ready
STANDARD VERSION LUMINAIRE INSTALLATION
1. 2. 3. 4. 5. 6. 7. 8.
Unclip the front cover using a flat blade screwdriver, and carefully inserting it into & releasing the 6 clip points (2 each side, one top & bottom). Secure the luminaire in position using the drill out points provided on the back wall of the luminaire body. Drill out the desired 20mm diameter cable entry point (located on each side wall of the luminaire body) & fit the cable gland provided. Route the power supply cable through the cable gland to the terminal block and terminate ensuring correct polarity is observed. Plug the Battery loom onto the PCB connector marked BATT. Rotate & angle the lamp heads to the required direction. The bolts/screws on the lamp heads may need to be loosened to do this – ensure they are re-tightened afterwards to hold position. Refit the front cover to the luminaire body. Connect the power supply & check that the green indicator LED illuminates.
****************************** IMPORTANT WARNING **************************** The luminaire uses Lithium Iron Phosphate cells (LiFeP04) in its battery pack. These batteries include overcharge protection circuitry and a Negative Temperature Co-efficient (NTC) third lead to control thermal runaway. When the battery is no longer able to provide its full rated duration, it must be replaced with an identical type. Please consult the manufacturer if in doubt. MAINTENANCE 1. This luminaire MUST be disconnected before the circuit it is installed on is subjected to any high voltage or insulation resistance testing, otherwise irreparable damage will occur to luminaire components. 2. Ensure cleanliness of luminaires is maintained so as not to affect performance. 3. The battery in this luminaire must be replaced when it is no longer able to meet its rated duration. 4. The luminaire operating temperature range is 0⁰C - +40⁰C.
1