1/2
FE427
eduard
LaGG-3 S.A. 1/48 scale detail set for ICM kit •sada detailů pro model ICM 1/48
FE427
ORIGINAL KIT PARTS PŮVODNÍ DÍLY STAVEBNICE
PHOTO-ETCHED PARTS LEPTANÉ DÍLY
16
B16
17
?
SYMETRICAL ASSEMBLY ´ SYMETRICKÁ MONTÁŹ REMOVE ODSTRANIT BEND OHNOUT REPLACE NAHRADIT GRIND OBROUSIT OPTION VOLBA
PARTS TO BE REMOVED DÍLY K ODSTRANĚNÍ
FILL TMELIT
A
LaGG-3 I.
La
GG
17 18
-3
23
B
15
II. 17 11
2 3
11
B8
15A 17
A
A16
56
22 22
B B16
13
A9
B9
1
20
=
10
D3
9
8 24
A13
25 7
For futher detail sets look for eduard 48 608 LaGG-3 Landing Flaps (not included in this set)
2/2
FE427
14 4
A1
B2
12 6
14 14 14 5 B3 B45
19 21 B15
14
FE 427
LaGG-3 S. A. 1/48 scale detail set for ICM kit • sada detailů pro model 1/48 ICM
3. Do not touch the adhesive areas of the etched components. 1. Separate the etched components from their frames on the protective paper. Removal from the paper is done only after separation of the parts from the frames.
3. Nesahejte na části dílů, na kterých je naneseno lepidlo.
1.Samolepící díly oddělujte od rámečku na podkladovém papíře. Po oddělení je sejměte z krycího papíru.
4. Samolepící díly berte za hrany nebo za části, na kterých není nanesené lepidlo.
4. Hold the parts by the edges, or at areas free of adhesive.
5. Lightly place the component in the desired location and position. Adjust as required. The component will by permanently affixed when pressed onto its intended location, its location can be adjusted.
2. Do not inadvertently place etched componets on an unwanted surface. Attempts to remove will result in damage to your part.
5. Díl lehce položte do pozice, ve které má být nalepen. Upravte přesnou pozici a přimáčkněte. Díl dokonale přilne až po přimáčknutí, před přimáčknutím lze dílem opatrně manipulovat.
2. Nepokládejte samolepící díly na volné plochy. Pokud je omylem přilepíte, při pokusu o odlepení dojde k poškození dílu.
Eduard M.A. © 2008
www.eduard.com
Made in Czech Republic