Skip to main content

ZDB_5416 30julio2026

Page 1


Después de ajustar todas las cajas minifix, cúbralas con las tapas adhesivas.

After you finish the adjustment of the cams, cover them with the cover caps.

5/8"

Al terminar de armar, desprenda las letras adhesivas.

After you finish assembling the cabinet, take off the adhesive letters.

ASSEMBLY INSTRUCTIONS

INSTRUCCIONES

DE ENSAMBLE LOT N° REF./SKU.

Alto: 128,7 cm

Ancho: 94,2 cm

Fondo: 24 cm

Height: 50,67 in

Width: 37,09 in

Depth: 9,45 in

Tel - (572) 691 17 00

PBX - (572) 695 91 81

Yumbo - Valle del Cauca - Colombia www.rta.com.co

RECOMENDACIONES

IMPORTANTES

No pintar el mueble.

El mueble debe ser usado únicamente en interiores, no exponer al sol directo

Limpiar los herrajes metálicos con un paño seco

NO sobrecargar el mueble (ver las cargas sugeridas).

No golpear ni martillar el mueble (solo cuando se indique).

Limpiar con un paño ligeramente húmedo, usar jabones suaves.

No arrastre el mueble, levántelo entre dos personas.

Evite el contacto directo con el agua, el fuego o la exposición a fuentes de calor

IMPORTANT RECOMMENDATIONS

Do not paint the cabinet.

The cabinet MUST be used exclusively indoors, do not expose to direct sun.

Clean metallic hardware with a dry cloth.

Do NOT overload the cabinet (see suggested loads).

Do not hit or hammer the cabinet (just when indicated).

Clean with a slightly damp cloth, use gentle soaps.

Do not drag, lift and move between two people

Avoid direct contact with water, fire or exposureto heat sources.

ADVERTENCIA

Nunca permita que los niños escalen o manipulen el mueble, la caída de este puede provocar lesiones graves o la muerte

Never allow children to climb or manipulate the cabinet, furniture tip over can cause serious injuries or death.

Tenga cuidado al voltear el mueble

Be careful turning over the cabinet.

Instalación del mueble a la pared 5/16 Drill bit. Broca de 5/16".

/ Inches

Fixing the cabinet to the wall

NECESARIAS*

included, and not shown actual size

HERRAJES PARA ARMADO

ASSEMBLY HARDWARE

Compruebe que el contenido de los herrajes sea el correcto. En caso de que falte alguna pieza, por favor llame a nuestra línea de atención al cliente

Please check that the hardware content is correct. If any item is missing, please call to our customer service line

9/16" x3 x3

5/8"

x16
Tarugo Wood Dowel x15
Minifix Minifix Cams
Perno Minifix Spreading Bolt x15
Tapa Adhesiva Minifix Cover Caps x10 x24
Tornillo Lámina 5/8" Flat Head Screw
Tapa Adhesiva Minifix Cover Caps x10 Color 1 Color 2

Gire para apretar

Rotate to tighten.

9/16" x3

HERRAJES PARA ARMADO ASSEMBLY

HARDWARE

Compruebe que el contenido de los herrajes sea el correcto. En caso de que falte alguna pieza, por favor llame a nuestra línea de atención al cliente

Please check that the hardware content is correct. If any item is missing, please call to our customer service line

x30

Tornillo Lámina 9/16" Flat Head Screw x3 Kit rack zapatero two layer Shoe holder kit x3 Manija (Incluye tornillos) Handle (Screws included)

x8

Deslizador Puntilla Nail-on Glide Chazo Mariposa + Tornillo Ensamble Wall Anchor + Drywall Screw x2

PIEZAS DE ARMADO ASSEMBLY PARTS

Rotate to tighten.
Gire para apretar

RECOMENDACIONES DE ENSAMBLE

ASSEMBLY RECOMMENDATIONS

Ensamble el mueble entre dos personas.

Ensamble el mueble sobre una superficie plana y lisa, preferiblemente sobre un tapete o el cartón de la caja

Lea cuidadosamente las instrucciones e identifique todas las piezas y herrajes antes de empezar a armar el mueble.

Assemble the cabinet between two people.

Assemble the cabinet on a flat, smooth surface, preferably on a carpeted floor or the box carton.

Carefully read all the steps and identify all the wood parts and hardware before assembling the cabinet.

Turn static files into dynamic content formats.

Create a flipbook
ZDB_5416 30julio2026 by Madecentro Colombia - Issuu