Skip to main content

VMP_3243 JULIO 2026

Page 1


MANIJA/Handle

BISAGRAVIDRIO/ Glass Hinge 1 2

APRETAR/ Tighten

Al finalizar el ajuste, cubra las cajas con las tapas adhesivas/ After tightening all the panels, cover the minifix camswiththeadhesivecaps.

PEGAR CINTA/ Stick Tape

ENCAJAR LA MANIJA A PRESIÓN/ Put the handle with some pressure

Alto/ 180 cm / Height: 70,87 in

Ancho/ 91,1 cm / Width: 35,87 in

Fondo/ 42,1 cm / Depth: 16,57 in

LOTE No:

Al terminar de armar, desprenda los adhesivos (en caso de que queden residuos de pegamento, limpie la superficie con alcohol) / After finishing the assembly, take off the adhesives (In case of glue residues,wipethemwithalcohol)

By:

TEL (572) 691 17 00 PBX (572) 695 91 81 CALI - COLOMBIA www.rta.com.co

VITRINASALEM /Salem Glass door cabinet

RECOMENDACIONES IMPORTANTES

KEY RECOMMENDATIONS

NO pinte el mueble / Do not paint the furniture.

NO lavar las manijas o tiraderas con jabones o elementos abrasivos / Do not wash handles or dumps with soap or abrasives.

NO mojar o ubicar a la intemperie / Do not expose to rain or direct sun.

NO sobrecargue el mueble. no exceda el peso de 30 kilos para gabinetes de cocina / Do not overload the cabinet. Weight max. 66lbs for kitchen cabinets. O O O O O

NO golpear ni martillar el mueble (hágalo sólo donde se indique) / Do not hit or hammer the furniture (just do it where is indicated).

NO permita que los niños manipulen el mueble, puede voltearse y lastimarlos / Do not allow children to handle the cabinets or drawers, they could get hurt.

SIEMPRE levante el mueble entre dos personas, NO lo arrastre / Do not drag thefurniture Lift it between two people.

Limpie con paño seco , / Clean with a dry cloth.

HERRAJES BÁSICOS PARA MUEBLES RTA

BASIC HARDWARE FOR RTA FURNITURE

1.Abrir la caja del mueble y buscar la bolsa con los herrajes / Open the box and look for the hardware bag.

2.Abrir el paquete y comprobar que el contenido de las piezas es correcto / Open the package and verify that the content of the pieces is correct.

3. Separe los herrajes para facilitar su identificación durante el armado / Separate hardware for easy identification during assembly.

4.Arme el mueble en un lugar limpio y en una superficie plana / RTAfurniture must be assembled in a clean place and on a flat surface.

AJUSTE DE ALTURA / HEIGHT ADJUSTMENT AJUSTE DE PROFUNDIDAD / DEPTH ADJUSTMENT AJUSTE LATERAL / LATERAL ADJUSTMENT D B C A K K H H H H H H H H E G I I K

Tornillo 2 1/2" + Chazo Mariposa/ Drywall Screw+ Wall Anchor

* Herramientas NO incluidas/ Tools not included

Utilizar una broca de 5/16" para hacer las perforaciones en el muro/ Use a 5/16" drill bit to drill the wall.

(3)Tightthepanelsbyturningtheminifixcam180°. PARED/WALL

El buen funcionamiento del mueble depende de un adecuado ensamblaje An excellent furniture´s performance relies on a solid and a suitable assembly. RECOMENDACIONES DE ENSAMBLE / ASSEMBLYRECOMENDATIONS

MINIFIX / CONNECTOR - DOWELS

B

Sistemadeunióncompuestoporunperno(A)yunacajaminifix(B).

(1)Seinsertalacajaminifixdentrodelaperforaciónubicadaenlacaradelapieza,laflechadebeapuntarsiemprea ladireccióndelaperforaciónpordondeentraráelperno.

(2)Sedebeinsertarelpernoporsuparteplásticaenlasperforacionesqueseindiquen,luegoseinsertalapunta metálicaenlaperforaciónparaquesucabezaquedealinteriordelacajaminifix.

(3)Girarlacajaminifix180°paraapretarlasdospiezas.

It´safittingsystemmadeofaspreadingbolt(A)andaminifixcam(B).

(1)Inserttheminifixcamintheholeplacedinthefaceofthepanelwiththearrowpontingtowardstheholewheretheboltwill fit.

(2)Inserttheboltwithitsplasticbaseintheshownholes,theninsertthemetallicboltheadintheholessoitfitsinsidethe minifixcam.

TARUGOS O TAQUETES / FLUTED DOWELPIN

caja minifix / dowels hole

Esunpedazodemaderacortoygrueso,deaproximadamente5a10cmdelargo,quesirveparaamarrarelmuebley darleresistencia.

It´s ashortandthickpieceofwood,1,9to3,9inchesaproximately,whichisusedtotiethecabinetandgiveitresistence.

Centímetros / Inches

RECOMENDACIONES IMPORTANTES / KEY RECOMMENDATIONS

PESO MAX. SUGERIDO EN MUEBLE (Kg) / MAX SUGGESTED LOAD (Kg)

Se recomienda armar el mueble sobre la caja o una superficie lisa para no rayarlo. It is recommended to assemble the product on the box or on a flat surface to not scratch it.

VOLTEAR TURN OVER

Voltear el mueble cuidadosamente para ensamblar los fondos. Carefully turn over the cabinet to assemble the back panels.

NOTA: La resistencia a las cargas puede variar dependiendo si es una carga distribuida o una carga puntual, las grácas corresponden a cargas puntuales, NO exceder los pesos sugeridos / NOTE: The load capacity depends if it is a point load or if it is an uniform distributed load, do not exceed the suggested loads.

Tarugo/ Fluted Dowel Pin

HERRAJES PARAARMADO

ASSEMBLY HARDWARE

Puntillas 1"/ Nails

Perno minifix/ Spreading Bolt

Girar 180° / Rotate 180° x16

Tornillo Lámina/ Sheet Screw x4

Minifix/ Minifix Cams

Tornillo 2 1/2" + Chazo Mariposa/ Drywal Screw+ Wall Anchor x4

Pata de Madera/ Wood Leg x10

Grapa para Fondo/ Staple

Tornillo Ensamble 3/4"/ Drywal Screw 3/4"

TENER PRECAUCIÓN AL ABRIR LA BOLSA DE HERRAJES PARA NO EXTRAVIAR NINGUNO. COMPRUEBE QUE EL CONTENIDO DE LAS PIEZAS SEA EL CORRECTO EN CASO QUE FALTE ALGUNA PIEZA O ESTE DEFECTUOSA DEVUELVA LAS PIEZAS AL ALMACÉN CON SU FACTURA PARA EFECTUAR EL CAMBIO DE LAS PIEZAS Y/O LOS HERRAJES LO MÁS PRONTO POSIBLE./ PLEASE BE CAUTIOUS WHEN OPENING THE HARDWARE BAG TO NOT LOSE ANY CHECK THE CONTENTS OF THE PARTS ARE CORRECT. IF ANY PART IS MISSING OR IMPERFECT PLEASE RETURN THE PARTS TO THE STORE WITH THE PRODUCT INVOICE ATTACHED TO MAKE EFECTIVE THE REPLACEMENT OF THE IMPERFECTPIECESORHARDWAREASSOONASPOSSIBLE.

x4
Bisagra Parche/ Full Overlay Hinge x70
Tapa Adhesiva
Minifix/ Cover Caps
Tiradera Metálica /Metallic Handle x2

HERRAJES PARAARMADO

ASSEMBLY HARDWARE

TENER PRECAUCIÓN AL ABRIR LA BOLSA DE HERRAJES PARA NO EXTRAVIAR NINGUNO. COMPRUEBE QUE EL CONTENIDO DE LAS PIEZAS SEA EL CORRECTO EN CASO QUE FALTE ALGUNA PIEZA O ESTE DEFECTUOSA DEVUELVA LAS PIEZAS AL ALMACÉN CON SU FACTURA PARA EFECTUAR EL CAMBIO DE LAS PIEZAS Y/O LOS HERRAJES LO MÁS PRONTO POSIBLE./ PLEASE BE CAUTIOUS WHEN OPENING THE HARDWARE BAG TO NOT LOSE ANY CHECK THE CONTENTS OF THE PARTS ARE CORRECT. IF ANY PART IS MISSING OR IMPERFECT PLEASE RETURN THE PARTS TO THE STORE WITH THE PRODUCT INVOICE ATTACHED TO MAKE EFECTIVE THE REPLACEMENT OF THE IMPERFECTPIECESORHARDWAREASSOONASPOSSIBLE. x2

VOLTEAR TURN OVER 3/4"

Vidrio/ Glass
Bisagra Puerta Vidrio /Glass Door Hinge
x4
Vaivén Magnético /Magnetic Stop

Girar 180° / Rotate 180°

PIEZAS DEARMADO ASSEMBLY PARTS

ANTES DE EMPEZAR A ARMAR EL MUEBLE LEA DETENIDAMENTE LAS INSTRUCCIONES. SE RECOMIENDA ARMAR EL MUEBLE SOBRE LA CAJA O SOBRE UNA SUPERFICIE LISA Y CUBIERTA, PARA NO RAYARLO / BEFORE STARTING TO ASSEMBLE THE CABINET, CAREFULLY READ THE INSTRUCTIONS. IT IS RECOMMENDED TO ASSEMBLE THE FURNITURE ON THE BOX OR ON A FLAT AND COVERED SURFACE IN ORDER TO NOT SCRATCH THE PRODUCT

*(Herramientas NO incluidas) *Tools NOT Included

Bisagra parche/ Full overlay hinge

VOLTEAR TURN OVER

Girar 180° / Rotate 180°
Girar 180° / Rotate 180° Hx8 Ix2

Girar 180° / Rotate 180°

VOLTEAR TURN OVER

Girar 180° / Rotate 180°

Turn static files into dynamic content formats.

Create a flipbook
VMP_3243 JULIO 2026 by Madecentro Colombia - Issuu