RECOMENDACIONES
IMPORTANTES
No pintar el mueble.
El mueble debe ser usado únicamente en interiores, no exponer al sol directo
Limpiar los herrajes metálicos con un paño seco
NO sobrecargar el mueble (ver las cargas sugeridas).
No golpear ni martillar el mueble (solo cuando se indique).
Limpiar con un paño ligeramente húmedo, usar jabones suaves.
No arrastre el mueble, levántelo entre dos personas.
Evite el contacto directo con el agua, el fuego o la exposición a fuentes de calor
IMPORTANT RECOMMENDATIONS
Do not paint the cabinet.
The cabinet MUST be used exclusively indoors, do not expose to direct sun.
Clean metallic hardware with a dry cloth.
Do NOT overload the cabinet (see suggested loads).
Do not hit or hammer the cabinet (just when indicated).
Clean with a slightly damp cloth, use gentle soaps.
Do not drag, lift and move between two people
Avoid direct contact with water, fire or exposureto heat sources.
ADVERTENCIA
Nunca permita que los niños escalen o manipulen el mueble, la caída de este puede provocar lesiones graves o la muerte
Never allow children to climb or manipulate the cabinet, furniture tip over can cause serious injuries or death. ! WARNING !
INSTALACIÓN BISAGRAS
A H H F C C E B G D J J J B
AJUSTE DE ALTURA J B AJUSTE DE PROFUNDIDAD J B J B AJUSTE DE LATERAL
Girar 180° / Rotated 180°
El buen funcionamiento del mueble depende de un adecuado ensamblaje An excellent furniture´s performance relies on a solid and a suitable assembly
MINIFIX / CONNECTOR - DOWELS
180°
1 2 3 A B
Sistema de unión compuesto por un perno (A) y una caja minifix (B).
(1) Se inserta la caja minifix dentro de la perforación ubicada en la cara de la pieza, la flecha debe apuntar siempre a la dirección de la perforación por donde entrará el perno.
(2) Se debe insertar el perno por su parte plástica en las perforaciones que se indiquen, luego se inserta la punta metálica en la perforación para que su cabeza quede al interior de la caja minifix.
(3) Girar la caja minifix 180° para apretar las dos piezas.
It´s a fitting system made of a spreading bolt (A) and a minifix cam (B).
(1) Insert the minifix cam in the hole placed in the face of the panel with the arrow ponting towards the hole where the bolt will fit.
(2) Insert the bolt with its plastic base in the shown holes, then insert the metallic bolt head in the holes so it fits inside the minifix cam.
(3)Tight the panels by turning the minifix cam 180°.
TARUGOS O TAQUETES / FLUTED DOWELPIN
1
Girar 180° / Rotated 180°
caja minifix / dowels hole
x
2
Es un pedazo de madera corto y grueso, de aproximadamente 3 a 10 cm de largo, que sirve para amarrar el mueble y darle resistencia.
It ´s a short and thick piece of wood, 1,18 to 3,9 inches aproximately, which is used to tie the cabinet and give it resistence.