Skip to main content

RLC_4265 29julio2026

Page 1


Instalación de las puertas

Door Installation

3 2

Depht adjustment Ajuste de profundidad

Side adjustment Ajuste lateral

4

Height adjustment Ajuste de altura

5

Después de ajustar todas las cajas minifix, cúbralas con las tapas adhesivas.

After you finish the adjustment of the cams, cover them with the cover caps.

Al terminar de armar, desprenda las letras adhesivas.

After you finish assembling the cabinet, take off the adhesive letters.

INSTRUCCIONES

DE ENSAMBLE ASSEMBLY INSTRUCTIONS

Alto: 61,7 cm

Ancho: 147,3 cm

Fondo: 40,7 cm

Height: 24,29 in

Width: 57,99 in

Depth: 16 in

Tel - (572) 691 17 00

PBX - (572) 695 91 81

Yumbo - Valle del Cauca - Colombia www.rta.com.co

RECOMENDACIONES

IMPORTANTES

No pintar el mueble.

El mueble debe ser usado únicamente en interiores, no exponer al sol directo

Limpiar los herrajes metálicos con un paño seco

NO sobrecargar el mueble (ver las cargas sugeridas).

No golpear ni martillar el mueble (solo cuando se indique).

Limpiar con un paño ligeramente húmedo, usar jabones suaves.

No arrastre el mueble, levántelo entre dos personas.

Evite el contacto directo con el agua, el fuego o la exposición a fuentes de calor

IMPORTANT RECOMMENDATIONS

Do not paint the cabinet.

The cabinet MUST be used exclusively indoors, do not expose to direct sun.

Clean metallic hardware with a dry cloth.

Do NOT overload the cabinet (see suggested loads).

Do not hit or hammer the cabinet (just when indicated).

Clean with a slightly damp cloth, use gentle soaps.

Do not drag, lift and move between two people

Avoid direct contact with water, fire or exposureto heat sources.

ADVERTENCIA

Nunca permita que los niños escalen o manipulen el mueble, la caída de este puede provocar lesiones graves o la muerte

Never allow children to climb or manipulate the cabinet, furniture tip over can cause serious injuries or death.

REQUIRED TOOLS* HERRAMIENTAS NECESARIAS*

*Not included, and not shown actual size *No incluidas y no se muestran en tamaño real.

HERRAJES PARA ARMADO ASSEMBLY HARDWARE

Please check that the hardware content is correct. If any item is missing, please call to our customer service line. Compruebe que el contenido de los herrajes sea el correcto. En caso de que falte alguna pieza, por favor llame a nuestra línea de atención al cliente

SlideDeslizar/
x72
Tarugo Wood Dowel
x35
Minifix Minifix Cams
Perno Minifix Spreading Bolt x35
Tapa Adhesiva Minifix Cover Caps x35
Bisagra Parche Full Overlay Hinge x2 x1
Manija Handle
Deslizador Puntilla Nail-on Glide x6
Tornillo Lámina Flat Head Screw x12
Tornillo Manija Handle Screw x2

! Do NOT tighten the cams in this step. NO apriete las cajas minifix en este paso. x2

PIEZAS DE ARMADO ASSEMBLY PARTS

! Do NOT tighten the cams in this step.

NO apriete las cajas minifix en este paso. x4

MAX SUGGESTED LOADS CARGAS MÁXIMAS SUGERIDAS

ASSEMBLY RECOMMENDATIONS

RECOMENDACIONES DE ENSAMBLE

Ensamble el mueble entre dos personas.

Ensamble el mueble sobre una superficie plana y lisa, preferiblemente sobre un tapete o el cartón de la caja

Assemble the cabinet between two people.

Assemble the cabinet on a flat, smooth surface, preferably on a carpeted floor or the box carton.

Lea cuidadosamente las instrucciones e identifique todas las piezas y herrajes antes de empezar a armar el mueble. www.rta.com.co

Carefully read all the steps and identify all the wood parts and hardware before assembling the cabinet.

NO apriete las cajas minifix en este paso. x2

! Do NOT tighten the cams in this step.

! Do NOT tighten the cams in this step.

NO apriete las cajas minifix en este paso. x2

NO apriete las cajas minifix en este paso x3

! Do NOT tighten the cams in this step

Turn minifix cams to the right to tighten. Gire las cajas minifix hacia la derecha para apretar las piezas.

! Do NOT tighten the cams in this step. NO apriete las cajas minifix en este paso. x2

Voltear Rotate

! Do NOT tighten the cams in this step. NO apriete las cajas minifix en este paso. x2

! Do NOT tighten the cams in this step.

NO apriete las cajas minifix en este paso. x3

Voltear Rotate

x2

Turn minifix cams to the right to tighten. Gire las cajas minifix hacia la derecha para apretar las piezas.

! Do NOT tighten the cams in this step. NO apriete las cajas minifix en este paso. x3

Do NOT tighten the cams in this step. NO apriete las cajas minifix en este paso. x4

Do NOT tighten the cams in this step. NO apriete las cajas minifix en este paso. x4

Do NOT tighten the cams in this step. NO apriete las cajas minifix en este paso. x2

Turn minifix cams to the right to tighten. Gire las cajas minifix hacia la derecha para apretar las piezas.

Turn static files into dynamic content formats.

Create a flipbook
RLC_4265 29julio2026 by Madecentro Colombia - Issuu