Skip to main content

CLB_6590

Page 1

THIS FURNITURE MUST BE FIXED TO THE WALL ! WARNING

Children have died from furniture tip over. To reduce the risk of tip over:

ALWAYS secure this furniture to the wall using a wall anchor. NEVER allow children to stand, climb, or hang on drawers, doors or shelves. Do not defeat or remove the drawer interlock system. Place heaviest items in the lowest drawers. NEVER put a TV on this furniture.


! IMPORTANT RECOMMENDATIONS Do not paint the cabinet.

RECOMENDACIONES IMPORTANTES No pintar el mueble.

The cabinet MUST be used exclusively indoors, do not expose to direct sun. Clean metallic hardware with a dry cloth.

Limpiar los herrajes metálicos con un paño seco.

Do NOT overload the cabinet (see suggested loads). NO sobrecargar el mueble (ver las cargas sugeridas).

Do not hit or hammer the cabinet (just when indicated).

No golpear ni martillar el mueble (solo cuando se indique).

Clean with a slightly damp cloth, use gentle soaps.

Limpiar con un paño ligeramente húmedo, usar jabones suaves.

Do not drag, lift and move between two people.

No arrastre el mueble, levántelo entre dos personas.

Avoid direct contact with water, fire or exposure to heat sources.

Evite el contacto directo con el agua, el fuego o la exposición a fuentes de calor.

!

!

WARNING Never allow children to climb or manipulate the cabinet, furniture tip over can cause serious injuries or death.

Page 2

Nunca permita que los niños escalen o manipulen el mueble, la caída de este puede provocar lesiones graves o la muerte.


INDEX

ÍNDICE

Assembly Hardware

4

Herrajes para Armado

4

Assembly Parts

5

Piezas de Armado

5

Suggested Loads

6

Cargas Sugeridas

6

Assembly Recommendations

6

Recomendaciones de Ensamble

6

Assembly Steps

7-17 Pasos de Armado

7-17

Warranty

18

18

Garantía

REQUIRED TOOLS*

HERRAMIENTAS NECESARIAS*

*Not included, and not shown actual size.

*No incluidas y no se muestran en tamaño real.

Page 3


ASSEMBLY HARDWARE

HERRAJES PARA ARMADO

Please check that the hardware content is correct. If any item is missing, please call to our customer service line.

Compruebe que el contenido de los herrajes sea el correcto. En caso de que falte alguna pieza, por favor llame a nuestra línea de atención al cliente.

x26

x26

x34

x26

x2

Minifix Cams Minifix

Spreading Bolt Perno Minifix

Wood Dowel Tarugo

Cover Caps Tapa Adhesiva Minifix

Wall anchor + screw Chazo + tornillo

x3

x8

x12

x6

x3

Drawer Slides (Includes screws) Rieles (Incluye tornillos)

Nail-on Glide Deslizador Puntilla

Drywall Screw Tornillo de Ensamble

Flat Head Screw Tornillo Lámina

Handle Manija Acero

Hardware items are NOT shown actual size.

Page 4

Los herrajes no se muestran en el tamaño real.


ASSEMBLY PARTS

PIEZAS DE ARMADO

A D B

M

E.F

F

H

M

E.P J

L

C

F

J

F

I

H L H

I L

K

I

K K

A - x1 B - x1 C - x1 D - x1 E.F - x1 Page 5

E.P - x1 F - x3 G - x3 H - x3 I - x3

J - x2 K - x3 L - x3 M - x2

G

G G


MAX SUGGESTED LOADS

CARGAS MÁXIMAS SUGERIDAS

33lb

15kg

22lb

10kg

22lb

10kg

22lb

10kg

Two people are recommended to assemble the product.

Ensamble el mueble entre dos personas.

Assemble the cabinet on a flat, smooth surface, preferably on a carpeted floor or the carton box of the product.

Ensamble el mueble sobre una superficie plana y lisa, preferiblemente sobre un tapete o el cartón de la caja

Carefully read the assembly instructions and identify every wood and hardware part before start assemblying the cabinet.

Lea cuidadosamente las instrucciones e identifique todas las piezas y herrajes antes de empezar a armar el mueble.

Page 6


1 x4 E.F

E.P

x4

2 x2

Jx2

x4 Page 7


3 J E.F

4

x4

J E.P

Page 8

Turn minifix cams to the right to tighten. Gire las cajas minifix hacia la derecha para apretar las piezas.


5 x4 D

6

x5 x2

C 4

Page 9

!


7 Rotate to tigten.

D

E.F J J

x5 C

8 x2 x2

B 4

Page 10

!


9 B Rotate to tigten.

x5

E.F J

D J C

10 x6

A

Page 11


11 B

M

E.F

D

J

J

M C

12

Rotate to tigten.

B

x6 A

M D

E.F J M C

Page 12

J


13 x2 Gx3 Fx3

14 x3 x4 F

Drywall Screw Tornillo de Ensamble

H

Page 13

G


15 x3 L

H

16 x3

Ix3

L

I

H

Page 14

G

G


17 x2

Kx3

x2 Rotate to tigten.

18 x3 x2 K

L

I H

Page 15

G


19

Fix your cabinet to the wall Fija el muebe a la pared

1

You must drill the bottoms guided by the holes in the structures wiht a 3/16" drill bit. Debes perforar los fondos guiandote de las perforaciones de las estructuras con una broca 3/16".

the wall, measure and mark the points shown below. 2 On En la pared, mide y marca los puntos que te indicamos abajo. Drill on the markings with a 5/16" drill bit. 3 Debes perforar en los puntos con taladro y una broca de 5/16".

4 Insert the wall anchors inside the drillings.

Inserta los chazos plásticos en las perforaciones.

the cabinet and secure it with the screws. 5 Place Ubica el mueble y asegúralo con los tornillos.

D

Dimensions in inches. Dimensiones en centimetros.

Page 16


20

A

K C

K

K

Deslice los cajones dentro del mueble.

After you finish the adjustment of the cams, cover them with the cover caps. Después de ajustar todas las cajas minifix, cúbralas con las tapas adhesivas.

Page 17

A

After you finish assembling the cabinet, take off the adhesive letters. Al terminar de armar, desprenda las letras adhesivas.


Furniture has a 1 year warranty coverage in wooden parts and hardware pieces since its manufacturing date, which you can see in the lot number printed on the product box and the assembly instructions leaflet. Warranty covers materials and workmanship imperfections which impair the assembly or correct functioning of the cabinet. This warranty is not valid if the defects or imperfections are caused by the incorrect following of the assembly instructions, warnings and recommendations, misuse, intentional damage, fire or flood, or after modifications or any kind of alteration, or repaired by someone not authorized, when it´s been assembled 3 months after the date of purchase. These defects MUST be reported before the warranty coverage period ends. Once the product has been assembled, the company will not be responsible for defective and/or damaged parts. This warranty is ONLY valid for the ORIGINAL PURCHASER, it doesn’t apply if the product has been resold, rented, etc. Furniture will take no liability for incidental or consequential damages caused to or by the product (This may not apply in your state). To make this warranty valid you must write to our customer service email describing the product defect, lot number and submitting your sales reciept or proof of purchase, or contact us at our customer service line. Replaced parts will be under the product´s original warranty coverage period. Damaged parts will become property of the company. There are no other warranties applicable to this product.

Page 18


Turn static files into dynamic content formats.

Create a flipbook
CLB_6590 by Madecentro Colombia - Issuu