Skip to main content

BMH_3130

Page 1


Repetir estos pasos con las piezas del otro módulo / Repeat these steps with the pieces of the other module Girar 180° / Rotate 180°

Alto: 180 cm

Ancho: 60 cm

Fondo: 28.65 cm

INSTRUCCIONES DE ENSAMBLE ASSEMBLY INSTRUCTIONS

Utilizar una broca de 5/16" para hacer las perforaciones en el muro/ Use a 5/16" drill bit to drill the wall.

Height: 70.9 in

Width: 23.6 in

Depth: 11.3 in

Tel - (572) 691 17 00

PBX - (572) 695 91 81

Yumbo - Valle del Cauca - Colombia www.rta.com.co

BIBLIOTECA BÁLTICA Báltica Bookcase

IMPORTANT RECOMMENDATIONS RECOMENDACIONES

IMPORTANTES

No pintar el mueble.

El mueble debe ser usado únicamente en interiores, no exponer al sol directo

Limpiar los herrajes metálicos con un paño seco

NO sobrecargar el mueble (ver las cargas sugeridas).

No golpear ni martillar el mueble (solo cuando se indique).

Limpiar con un paño ligeramente húmedo, usar jabones suaves.

No arrastre el mueble, levántelo entre dos personas.

Evite el contacto directo con el agua, el fuego o la exposición a fuentes de calor

ADVERTENCIA

Nunca permita que los niños escalen o manipulen el mueble, la caída de este puede provocar lesiones graves o la muerte

Do not paint the cabinet.

The cabinet MUST be used exclusively indoors, do not expose to direct sun.

Clean metallic hardware with a dry cloth.

Do NOT overload the cabinet (see suggested loads).

Do not hit or hammer the cabinet (just when indicated).

Clean with a slightly damp cloth, use gentle soaps.

Do not drag, lift and move between two people

Avoid direct contact with water, fire or exposureto heat sources.

WARNING !

Never allow children to climb or manipulate the cabinet, furniture tip over can cause serious injuries or death. !

180° / Rotate 180°

Girar 180° / Rotate 180°

AAl terminar de armar, desprenda las letras adhesivas.

After you finish assembling the cabinet, take off the adhesive letters.

Girar

180° / Rotate 180°

De un adecuado armado del mueble depende su buen funcionamiento. Armed with a suitable furniture depends on its smooth functioning.

MINIFIX / CONNECTOR - DOWELS

1 2 3

1

Es un herraje de unión, la cabeza esférica del perno se ubica en el centrodelacajaembutidaenformadecopadesdecualquieránguloy luego se sujeta firmemente. Este permite un arme y desarme repetidamenteyunauniónfirmequenoseafloja.

Itisahardwareunion,sphericalheadofthepinislocatedinthecenterofthe boxembossedintheformofglassfromanyangleandthensubjectfirmly Thisallowsforarminganddisarmingrepeatedlyandastrongunionthatis notloosened.

TARUGOS O TAQUETES / FLUTED DOWELPIN

Tarugo / Fluted dowel pin caja minifix / dowels hole

x

2

Es un pedazo de madera corto ygrueso, aprox. de 5cm a10cm, quesirvepara amarrarel mueble ydarleresistencia. It is a piece of wood short andthick,aprox.5cmto10cm,whichserves totiethe cabinet and give it strength.

Girar
/ Rotate 180°

HERRAJES PARAARMADO ASSEMBLY

HARDWARE

x30 x30

Minifix/ Minifix Cams

Perno minifix/ Spreading Bolt

x4

Tornillo 2 1/2" + Chazo Mariposa/ Drywall Screw+ Wall Anchor

x4

x72 Tarugo/ Fluted Dowel Pin

Tornillo de Ensamble 3/4"/ 3/4" Drywall Screw x4

Deslizador/ Plastic Glide

x18

x12

Tapa Adhesiva

Minifix (color 1)/ Cover Caps

Tapa Adhesiva

Minifix (Color 2)/ Cover Caps

TENER PRECAUCIÓN AL ABRIR LA BOLSA DE HERRAJES PARA NO EXTRAVIAR NINGUNO. COMPRUEBE QUE ELCONTENIDO DE LAS PIEZAS SEAELCORRECTO. EN CASO QUE FALTE ALGUNAPIEZAO ESTÉ DEFECTUOSADEVUELVALAS PIEZASALALMACÉN CON SU FACTURAPARA EFECTUAR ELCAMBIO DE LAS PIEZASY/O LOS HERRAJES LO MÁS PRONTO POSIBLE./ PLEASE BE CAUTIOUS WHEN OPENING THE HARDWARE BAG TO NOT LOSE ANY. CHECK THE CONTENTS OF THE PARTS ARE CORRECT. IF ANY PART IS MISSING OR IMPERFECT PLEASE RETURN THE PARTS TO THE STORE WITH THE PRODUCT INVOICE ATTACHED TO MAKE EFFECTIVE THE REPLACEMENT OF THE IMPERFECT PIECES OR HARDWARE AS SOON AS POSSIBLE.

PIEZAS DEARMADO ASSEMBLY PARTS

ANTES DE EMPEZAR A ARMAR EL MUEBLE LEA DETENIDAMENTE LAS INSTRUCCIONES. SE RECOMIENDA ARMAR EL MUEBLE SOBRE LA CAJA O SOBRE UNA SUPERFICIE LISA Y CUBIERTA, PARA NO RAYARLO / BEFORE STARTING TO ASSEMBLE THE CABINET, CAREFULLY READ THE INSTRUCTIONS. IT´S RECOMMENDED TO ASSEMBLE THE CABINET ON THE BOX OR ON A FLAT AND COVERED SURFACE IN ORDER TO NOT SCRATCH THE PRODUCT

NO incluidas) *Tools NOT Included

Turn static files into dynamic content formats.

Create a flipbook
BMH_3130 by Madecentro Colombia - Issuu