GR AN ADA PEN DANT
2 1 2 . 6 2 5 .9 6 0 5
INSTAL L IN ST R UCT IONS
ST U D I O @ L AV IVAHOM E.C OM
ADJUSTAB LE ON SI TE
PAGE 1 OF 2
DATE 10.13.22
PLEASE NOTE
CONTENTS
All of our lighting is carefully inspected and electrically tested
•
Glass Shade Assembly
•
Adjustable Link Chain
prior to shipping. Once received, we ask that you please inspect thoroughly—prior to installation—for any physical
(3 ft Standard, Adjustable on Site)
defects which may have occurred during shipping. Lighting that has been installed is not eligible for return or exchange, and L’Aviva Home does not take any responsibility for any damage incurred during installation itself.
Please be sure, too, to note the maximum recommended wattage for your fixture when choosing a bulb; using higher wattage bulbs can short the wiring, and L’Aviva Home does not take responsibility for any damage incurred under these circumstances.
CAREFULLY REMOVE FIXTURE FROM PACKING MATERIALS
•
Canopy
•
1/4 IPS Hang Straight Screw Collar Loop
•
Cross Bar
•
8-32 Cross Bar Screws (2x)
•
Wire Nuts (2x)
•
Canopy Lock Washer
•
Canopy Nut
GR AN ADA PEN DANT
2 1 2 . 6 2 5 .9 6 0 5
INSTAL L IN ST R UCT IONS
ST U D I O @ L AV IVAHOM E.C OM
ADJUSTABLE ON SI TE
PAGE 2 OF 2
DATE 10.13.22
Nut
INSTALLATION
Ground Screw Cross Bar
1. This product must be installed in accordance with applicable installation code by a person familiar with the construction and operation of the product and the hazards involved. 2. Turn off power to junction box before installing. 3. Adjust link chain to desired length. 4. Install the crossbar using #8-32 screws to the junction box. Pull
8-32 Screws
Canopy 1/4 IPS Threaded
the main wires out so they are accessible while making the main connection later. 5. Once the crossbar is secure, connect the ground wire to the ground screw on the cross bar. 6. Screw the 1/4 IPS nipple into the hang straight loop and then into the crossbar. 7. Unscrew the screw collar from the hang straight loop. Feed onto the wire and chain from the fixture, followed by the canopy. 8. Carefully raise fixture to ceiling and hold, attach chain to loop. 9. Guide the lead wire through the hang straight loop into the junction box.
Hang Straight Loop
10. Crimp the C-shaped strain relief around the lead wire just above the crossbar. Strip wires and make connections to the leads in the ceiling with provided wire nuts.
Screw Collar
11. Tuck the connected wires into the junction box and raise the canopy and hang straight nut. 12. Thread the screw collar onto the hang straight, tightening the canopy flush to the ceiling. 13. Install E26 Bulb (60W max), then supply power to the fixture.
Adjustable Chain