AGAVE PEN DANT
2 1 2 . 6 2 5 .9 6 0 5
INSTA L L INST R UC T ION S
ST U D I O @ L AV IVAHOM E.C OM
DATE 10.13.22
PLEASE NOTE
FI X ED LENGTH
PAGE 1 OF 2
CAREFULLY REMOVE FIXTURE FROM PACKING MATERIALS
All of our lighting is carefully inspected and electrically tested prior to shipping. Once received, we ask that you please inspect thoroughly—prior to installation—for any physical
CONTENTS
defects which may have occurred during shipping. Lighting that has been installed is not eligible for return or
•
Glass Shade
•
Stem Coupling
•
1/8 IPS Stem Assembly & Threaded Nipple
•
Universal Cross Bar
•
Canopy Lock Washer
•
Canopy Nut
using higher wattage bulbs can short the wiring, and L’Aviva
•
Canopy
Home does not take responsibility for any damage incurred
•
Screw Caps (2x)
•
Wire Nuts (2x)
•
E26 Bulb, G25 LED
exchange, and L’Aviva Home does not take any responsibility for any damage incurred during installation itself.
Each fixture includes a compatible bulb. In the event that a replacement bulb is used, for any reason, please be sure to note the maximum recommended wattage for your fixture:
under these circumstances. Every piece in this collection is handblown and unique; variation in thickness, tone, and silhouette is to be expected as part of the handblown glass's inherent characteristics. Markings, lines and air bubbles are a natural part of the glass’s beauty.
AGAVE PEN DANT
2 1 2 . 6 2 5 .9 6 0 5
INSTAL L INST R UC T ION S
ST U D I O @ L AV IVAHOM E.C OM
FI X ED LENGTH
PAGE 2 OF 2
DATE 10.13.22
INSTALLATION 1. This product must be installed in accordance with applicable
8-32 Screws
installation code by a person familiar with the construction and operation of the product and the hazards involved. 2. Turn off power to junction box before installing.
Cross Bar
Ground Screw
3. Feed wires from the fixture body up through stem assembly with the stem coupling end up. 4. Thread stem assembly into coupling on fixture body and secure Canopy
with set screw (in coupling) and apply locktite to the threaded joints.
Threaded Nipple Nut
5. Slip canopy onto threaded stem assembly and rest on top of coupling on fixture body and secure the canopy to the stem with lock washer and nut. 6. Install thread universal cross bar (with installed 2x 8-32 screws pointed down towards fixture body) onto junction box. 7. Attach ground wire to ground screw on bracket bar. 8. Perform wire makeup using (2 provided) wire nuts - ensuring proper polarity. 9. Recess wire connections within junction box.
Screw Cap
10. Raise fixture and canopy up to installed cross bar and junction box, slip the 8-32 screws through the 2 holes in the canopy and secure in place with lock balls (2 provided). Stem Assembly
11. Install (1) E26 LED Bulb, then supply power to the fixture.