International Research Journal of Engineering and Technology (IRJET)
e-ISSN: 2395-0056
Volume: 09 Issue: 09 | Sep 2022
p-ISSN: 2395-0072
www.irjet.net
IOT Based Three Phase Transmission Line Fault Detection and Classification Krushna Nikam1, Vishakha Baviskar2, Jaydeep Patil3, Mohit Mahajan4, Manish D Mahale5 1,2,3,4 Research
Scholars, Department of Electrical Engineering Professor, Department of Electrical Engineering G H Raisoni Institute of Business Management Jalgaon ---------------------------------------------------------------------***--------------------------------------------------------------------5Assistant
Abstract -In the current scenario transmission line fault
This paper clarified to the perfect detection of fault. In the use of wavelet analysis or power system translators. In this system a huge ability to spoil the current and voltage signal. In this method used wavelet which shows light signal and provide more features[6].
Detection is major and important issue. In transmission line 85-87% faults of power system occur in these overhead Transmission line. In this paper, we discuss about various Method to control the fault generated in transmission line and solve this in real time. The heart of this module is Aurdino and IOT based software this will detect the fault, and exact location of fault also which type of fault. It Will shows in display and software also be in this information is transmitted to the control room.
Clarified that the paper aims to design the fault detection system with the help of autorecloser of overhead or three phase system with data acquisition system that says this method is very hardly to detect the fault on transmission lines [7].
Keywords- Aurdino, Relay, LCD display, IOT software, P.T
This system will deplete the man power off closing the circuit breaker. This pater shows the in such many solve the problems faced in transmission line and consumers by using the method, we can easily detect the fault and resolve it and problem solved in real line very useful for the future.
1. INTRODUCTION In the current time electricity is the most important part in human being and day to day life cycle. Faults on transmission line can be cause mechanical failure, excessive internal and external stresses, lightning strikes etc. In transmission line such type of fault three phase line to line fault, three phase line to ground fault, Double line to ground fault. Power system is classified into three main types like this, power generation, transmission and distribution transmission system is considered to main part of the power system. Current scenario as it lot supply and demand of transmission network. Due to the fault in transmission line disturb the supply of power to the consumer. There are some benefits to accurate fault detection system, because including less time to save electricity, low maintenance cost, save the electrical equipment’s. In current time of India, A system is not detect the fault in real time these type of system lot of hazardous in transmission network.
3. METHODOLOGY Here we design a simple prototype model of 3 phase fault detection system. The impedance of transmission line is proportional to the line length. So here we utilized combination of resistance in series, for each phase, one relay is use to isolate the load at the time of fault which give exact length of fault occur on line. The mastermind of our project is Aurdino Uno. The DC supply is require for controlling board. Which is provides with the help of rectifier and transformer combination. Output switches is given analog pin or Aurdino (Uno) and display is also connected to digital output pin of Aurdino. So when we move fault it indicate of display with exact distance, and at a same time Aurdino give output to mp really and it disconnect load from supply. This all thing happen as soon as fault is occur in line. Due to proper program insert in Aurdino on a based. It is possible become voltage of Ade pin is changes according to flowing from line and it depend upon distance of line.
2. LITERATURE SURVEY In this paper clarified to the overhead Transmission system protection is very crucial thing in current scenario, because in power system 85 to 87% of power system faults are coming off in transmission lines. Classify the perfect technique, to detect the fault in transmission line, like line to line fault, line to ground fault etc.[5]
© 2022, IRJET
|
Impact Factor value: 7.529
4. OBJECTIVE In this paper we shall discuss about transmission line fault. The main objective of this prototype model we try to make efforts less system to decreases human work and hazard
|
ISO 9001:2008 Certified Journal
|
Page 671