International Research Journal of Engineering and Technology (IRJET)
e-ISSN: 2395-0056
Volume: 09 Issue: 06 | June 2022
p-ISSN: 2395-0072
www.irjet.net
Drowsiness Detected For Vehicle Using Smart Glass With Eye Blink Sensor PRAKASH N1, PRAVEEN KUMAR C2, RAJASEKAR M3 1
Associate Professor, Department of Electrical and Electronics Engineering, Kumaraguru College of Technology [autonomous], Coimbatore, India 234
Department of Electrical and Electronics Engineering, Kumaraguru College of Technology [autonomous],
Coimbatore, India ---------------------------------------------------------------------***--------------------------------------------------------------------Drowsiness with driving is a very hazardous and it is very Abstract - For this project we use an instant blink sensor to difficult to identify.
detect the driver's drowsiness using a wearable glass. The driver should wear a blink sensor when driving for a long time should be a few seconds to see drowsiness. Blinking the eyes is a quick act of closing and opening the eyelids. Dangers of drowsiness can be controlled and prevented with the help of the blink sensor using IR radiation. Contains an IR transmitter and IR receiver. The transmitter transmits IR radiation to the eye. If eye get closed, then the output is high. If eye is open, IR receiver gets low output. This output is connected by an alarm connected to a smart glass. This module can be connected to a car braking system and can be used to reduce car speed. The alarm inside the car will sound for a while until the driver regains consciousness. If the driver is unable to control the vehicle after the specified time, it will cut off the power supply to the vehicle when applying the brakes on the vehicle.
After alcohol drowsiness is the second leading cause of the road accident .we must take awerness about this and fallow traffic rules to drive the vehicle safely. I hope in our project reduce 50% of road accident due to drowsiness
2. METHODOLOGY
Key Words: IR sensor, Arduino, LCD display, Transmitter and Receiver, Relay, DC motor.
1. INTRODUCTION The proposed smart system is divided into two parts :
Driver drowsiness detection is a car Safety technology which helps prevent accidents caused by the driver getting drowsy. Various studies have suggested that around 20% of all road accidents are fatigue-related up to 50% on certain roads. For this survey we are looking for to search number of road accidents is happened is passed by the U.S. National Highway Traffic Safety
This state of mind causes the driver to lose his/her attention from the current scenario and the ability to react against various phenomena. Hence it is very much necessary to take preventive measures to detect the drowsiness of the person on road so as to prevent the road accidents caused by the drowsiness of the driver,
|
Impact Factor value: 7.529
The transmitter parts consists of Arduino Uno-I ,IR sensor ,buzzer, power supply ,RF transmitter and lcd display fro displaying the drowsiness detection alert systems.
The receiver part consists of another Arduino UnoII , one relay module and gear motor.
We are using wearable glass. In that one side of glass fixing IR sensor continuously monitoring eye pupil and sends signal to Arduino uno-I. IR sensor has transmitter and receiver it sends IR radiation to eye pupil it reflects the rays. After reflection if output is high it takes eyelid is in closed condition and else output is low eyelid in open condition.
Administration reports 40,000 injuries and 1550 deaths due to car crashes every year, 31% of which were because of driver’s drowsy state while driving.
© 2022, IRJET
•
If IR sensor receives high output it takes driver in drowsiness then Arduino sends signal to buzzer to alarming 3 sec for try to wake up the driver.
|
ISO 9001:2008 Certified Journal
|
Page 342