International Research Journal of Engineering and Technology (IRJET) Volume: 10 Issue: 04 | Apr 2023
e-ISSN: 2395-0056 p-ISSN: 2395-0072
www.irjet.net
ANALYSIS OF POWER WIRE COMMUNICATION SYSTEM Vaibhav V Rajguru1, A.U Wagdarikar2 1PG Student,VVPIET Solapur,Maharashtra, India. 2Professor, Faculty of Engineering, VVPIET , Solapur,Maharashtra,India.
------------------------------------------------------------------------***------------------------------------------------------------------------Abstract: The communication over power wire we can 2: Author review use for transferring data on low and medium speed. This communication allows to reduce wires used for sensor networks, signal wires and data transmission. It can use for vehicles having more number of sensing elements and number of BCM of featured vehicle. So sensors are connected with transmitter controller board via cable, Power wire transmitter will transmit sensor data over same power wire which provides power to sensor device, transmitter and receiver board. This communication will be the good solution for reducing number of wires for multiple sensor device interfacing. The major application area for this system would be electrical vehicle which have multiple sensor networks and complex wiring.
Keywords: BCM, Electrical vehicle, Sensors, Wiring, Power Wire communication.
1. INTRODUCATION: As a dependable alternative networking medium, this study offers communication on power wire system that allows in-vehicle communication for the transmission of control messages and sensor data from sensor location to receiver control module. The Power wire Communication can be sue for multiple sensor networking, sending short data massages and vehicle system uses an existing DC/AC power wires as the communication media, which doesn’t require an additional signal wires for sending data and signals in-vehicle signal transmission. We can achieve the reduction of number of wiring harness from a system where large number of sensors and slave network works. For example, solar panels are located at far distance from control station in solar electricity generation system. Power Wire Communication will help to send data like solar panel position altitude, voltage and current measurement near to the solar panel terminals which is quite difficult with manually for every solar panel. Second example is we can utilize this system for features of vehicle (Stop light, reverse light, number plate light, demister, rear wiper, rear indicators) with the safety features like short circuit protection, fault protection and feedback to vehicle control unit. This power Wire communication will eliminate the number of wires, complexity of wiring harness design, weight of wire and production of wiring harness. Hence cost will come down. © 2023, IRJET
|
Impact Factor value: 8.226
|
Analysis Review result of author 1: Sheng-Xiu Lin, Yuan-Hua Zhang, Chao-Tang Yu, WeiWen Hu, Liang-Bi Chen, and Wan-Jung Chang – “A DC Power-Line Communication based In-Vehicle Safety Aided System for Rear Vehicles Road Safety” [3] This paper proposes an in-vehicle safety aided system, which adopts DC power-line communication (DC PLC) as a main transmission channel. The system is composed with
Voice-to-text (VTT) module
Two embedded computer modules
Two DC PLC transceiver modules
Text and video message display module
Distance measurement module.
Moreover, the proposed system is successfully installed and tested in a real vehicle. The experimental results showed that the proposed system can have a data of distance to the adjacent rear vehicle, and display front view video with alerting messages for drivers of rear vehicles. Analysis Review result of author 2: S. Barmada, M. Raugi, M. Tucci, T. Zheng - “Power Line Communication in a Full Electric Vehicle: Measurements, Modelling and Analysis”.[2] The technological implementation is nowadays done by using different data bus (Local Interconnect Network, Controller Area Network, Media Oriented Systems Transport, FlexRay), depending on the required communication speed and reliability.
A modern vehicle of average dimension is characterized by a communication grid of several km, with a constantly increasing number of connection points (more than 200 nowadays).
The weight of the wiring harness is second only compared to the engine – gearbox weight. It is not
ISO 9001:2008 Certified Journal
|
Page 507