Instruction Manual Intrim 800 Series Shadowline® System NOTE:
1. Door Jamb Assembly Cut DJ800 door jamb material to required lengths with a 45-degree mitre cut to the JOINT NAILED & GLUED WITH PVA ADHESIVE
with PVA glue and nails or screws. (Detail A) (Refer to Figure 1)
2. Door Jamb Install & Fixing Skirting
WALL FRAME SECTION
TOP PLATE
DETAIL A SCALE 1 : 5
DJ800 DOOR JAMB STILE AND HEAD MITRE JOINT METHOD
JOINTS NAILED & GLUED
STUD
A NOGGIN
Pack opening and install DJ800 door jamb plumb and level. Take care when installing jamb material, to make sure it (example – if framework is 90mm wide and plasterboard is 10mm thick = 90mm frame + (2 x 10mm) 2 thicknesses of plasterboard + (2 x 3.5mm) 2 thicknesses of plaster set = 117mm total width of
DJ800 DOOR JAMB
BOTTOM PLATE
FIGURE 1 - DOOR JAMB ASSEMBLY DETAILS door jamb face = (117 – 90) divided by 2 = 13.5mm on both sides between the jamb face and framework face. (Detail B) Once all DJ800 door jambs are installed, it
and external corners of framework. Cut for internal and external corners. Use a splice joint when joining the skirting ends together over a straight wall section. This joint must be formed over the centre of the wall frame stud. A butt joint is not acceptable.
steel frame, into every stud at a maximum distance of 600mm centres. (minimum
FIGURE 2 - SKIRTING FIXING DETAILS per stud for 235 to 285mm wide). These
Install with 5mm packers between the
NOTE:
for any subframe movement.(Detail B) (Refer to Figure 2)
1800 622 081
intrimmouldings.com.au