8
V
http://doi.org/10.22214/ijraset.2020.5182
May 2020
International Journal for Research in Applied Science & Engineering Technology (IJRASET) ISSN: 2321-9653; IC Value: 45.98; SJ Impact Factor: 7.429 Volume 8 Issue V May 2020- Available at www.ijraset.com
Geometrical Construction of Solar Eclipse Himani Patel1 , Akash Patel2 1,2
P.G. Department of Physics, Sardar Patel University, Vallabh Vidhyanagar, India
Abstract: Geometrical Construction of annular solar Eclipse on 26th December 2019. In this projection of the solar eclipse assumes that observer is at moon, looking down on earth, viewing the moon’s shadow as it passes over the earth disc. The earth to him appears as a plane equal to the moon’s horizontal parallax. Keywords: Elements for computations, Graph, observations from the projection, Results from Graph I. INTRODUCTION Solar eclipse occurs when the moon passes between earth and the sun, thereby totally or partially obscuring earth’s view of the sun. This configuration can only occur during a new moon when the sun and moon are in conjunction as seen from the earth.
A. Types of Eclipse Depending on what part of the shadow you are located in there are three types of eclipse: 1) Total Eclipse: A total eclipse is where the sun is covered completely by the Moon. 2) Annular Eclipse: An annular eclipse is when the moon covers the sun, but the sun can be seen around the edge of the moon. 3) Partial Eclipse: A partial eclipse is where when only a portion of the sun is blocked by the moon.
©IJRASET: All Rights are Reserved
1150
International Journal for Research in Applied Science & Engineering Technology (IJRASET) ISSN: 2321-9653; IC Value: 45.98; SJ Impact Factor: 7.429 Volume 8 Issue V May 2020- Available at www.ijraset.com B. Some Definitions Central solar eclipse: It is an eclipse during which the central line of the umbra touches the Earth’s surface. It is possible, Though extremely rare, that part of the umbra intersects with the Earth (Thus creating an annular or total eclipse), but not its central line. This is then called a non-central total or annular eclipse. 1) Greatest Eclipse: For solar eclipses, Greatest Eclipse (GE) is defined as the instant when the axis of the moon’s shadow cone passes closest to Earth’s center. The computation of the duration of the total (or annular) phase at this point is typically done using a smooth edge for the Moon that ignores the effects of mountains and valleys along the lunar limb. For total eclipses, the instant of Greatest Eclipse offers a good approximation (typically ~1-2 seconds) to the Greatest Duration of totality along the entire eclipse path. The instant of Greatest Eclipse is easily calculated for total, annular and partial eclipses, and is the standard time used for comparing different eclipses with each other. For annular eclipses, the instant of Greatest Duration may occur either near the time of Greatest Eclipse or near the sunrise and sunset for lunar eclipses, Greatest Eclipse is defined as the instant when the moon passes closest to the axis of Earth’s shadow. 2) Penumbra: Faint outer shadow; partial eclipse are seen from within this shadow 3) Umbra: Dark inner shadow; total eclipse are seen from within this shadow. 4) Node Point: The moon’s orbit is inclined about 5o8’ to earth’s orbit around the sun. The points where the lunar orbit intersects the plane of earth’s orbit are known as the nodes. The moon moves from south to north of earths orbit at the ascending node, and from north to south at the descending node. 5) Declination: The earth’s equator is tilted 23.45 degrees with respect to the plane of the earth’s orbit around the sun, so at various times during the year, as the earth orbits the sun, declination varies from 23.45 degrees north to 23.45 degrees south.
LINE SE
SUN EARTH Moon’s Parallax- It is defined as an angle subtended at the moon by the earth radius. 6) Greenwich Time (GMT): Universal Time is actually based on the mean sidereal time as measured in Greenwich, England. It’s also approximately equal to mean solar time from Greenwich.
©IJRASET: All Rights are Reserved
1151
International Journal for Research in Applied Science & Engineering Technology (IJRASET) ISSN: 2321-9653; IC Value: 45.98; SJ Impact Factor: 7.429 Volume 8 Issue V May 2020- Available at www.ijraset.com II. CONSTRUCTION OF THE GENERAL ECLIPSE The projection can be drawn on any reasonable size of blank paper but will be very convenient on big graph paper. A. STEP-1 Find moon’s Horizontal Parallax- sun’s Horizontal Parallax =0̊ 58́ 44̋ - 0̊ 0́ 8.5̋ =58.6́ (88 mm) (Take a suitable scale 1́ = 1.5 mm) Now draw a circle with radius 88mm with centre as C. Draw a horizontal line BCH passing through C and representing the diameter of the circle. B. STEP-2 Through C draw line CDPL perpendicular to HB. This line represents the plane of earth’s axis as seen from moon. C. STEP-3 Draw another circle with radius equal to Moon’s Horizontal Parallax – sun’s Horizontal Parallax = a Sun’s semi-diameter + moon’s semi-diameter = b Now take a+ b = 0̊ 58́ 35.5̋ + 0̊ 31́ 48.5̋ = 1̊ 30́ 23̋ = 90.40́ = 135.75mm D. STEP-4 From P take PA and PF each equal to obliquity of eclipse 23̊ 26̍ and draw a chord AF with AF as the diameter describing semicircle ALF. Point A represents Vernal Equinox, F the Autumn Equinox where as D represents the two tropics. E. STEP-5 Find the distance of sun from the tropic nearest to it. 274̊ 6̍ 55.1̋ - 90̊ = 184̊ 6̍ 55.1̋ 274̊ 6̍ 55.1̋ - 270̊ = 4̊ 6̍ 55.1̋ Longitude of sun is nearest to 270̊ Take LT equal to 48̊ 21̍ 12̋ and draw TE parallel to LC. F. STEP-6 Draw CG the axis of moon’s orbit so that angle GCE is equal to moon’s visible path with the ecliptic. CG is to the left of CE if node is Ascending. CG is to the right of CE if node is Descending. Here, we are calculating for 26th December 2019 solar eclipse which is descending node. G. STEP-7 Take Cn= Moon’s latitude. Here, 44.73mm. Draw a line which passes through n & which is perpendicular to CG. Here line k l r m n p q. This line represents the centre of shadow or moon’s path across the disc. Join points Ck, C1, C2, Cq H. STEP-8 Take moon’s semi-diameter as radius (15̍ 33̋ = 23.32mm) and draw moon’s disc centered at points k & q. Take sun’s semi-diameter as radius (16̍ 15.5̋ = 24.38mm) and draw sun’s disc centered at points 1& 2.
©IJRASET: All Rights are Reserved
1152
International Journal for Research in Applied Science & Engineering Technology (IJRASET) ISSN: 2321-9653; IC Value: 45.98; SJ Impact Factor: 7.429 Volume 8 Issue V May 2020- Available at www.ijraset.com I. STEP-9 Moon’s hourly motion – Sun’s hourly motion = 0̊ 30̍ 24.8̋ = 45.61mm III. ELEMENTS FOR COMPUTATIONS The arguments which are required for plotting (projecting) the annular solar eclipses of 26th December 2019 at the time of new moon are… Sr no. 1 2 3 4 5 6 7 8 9 10 11 12 13
Observations Longitude of sun Declination of sun Sun’s hourly motion in longitude Sun’s horiontal parallax Sun’s semi diameter Longitude of moon Moon’s hourly motion in longitude Moon’s horizontal parallax Moon’s semi diameter Moon’s latitude Moon’s hourly motion in latitude Angle of moon’s path with eciptic Node of moon
Degree( ̊ ) 274 23 0 0 0 274 0 0 0 0 0 5 Decending node IV.
©IJRASET: All Rights are Reserved
Minitues( ̍ ) 6 22 2 0 16 7 32 58 15 23 3 8
Seconds( ̋ ) 55.1 25.4 32.9 8.5 15.5 31.2 57.7 44 33 36 2.35 42
GRAPH
1153
International Journal for Research in Applied Science & Engineering Technology (IJRASET) ISSN: 2321-9653; IC Value: 45.98; SJ Impact Factor: 7.429 Volume 8 Issue V May 2020- Available at www.ijraset.com V.
OBSERVATION FROM THE PROJECTION
kl = 54mm
1h 6m 3s
Kr = 122mm
2h 42m 35s
Km = 133mm
2h 43m 49s
Kn = 129mm
2h 38m 53s
Kp = 203mm
4h 10m 3s
Kq = 258mm
5h 17m 47s
kl = 54mm
1h 6m 3s
lr = 75mm
1h 32m 23s
rm = 1mm
0h 43m 49s
mn = 4mm
2h 1m 13.9s
np = 74mm
0h 4m 55s
pq = 55mm
1h 7m 44s
kCH = 16̊ lCH = 28̊ pCB = 35̊ qCB = 24̊
VI. RESULTS FROM GRAPH A. Time Of Conjuction At Greenwich: 5h 15m 29s -k to n
5H 15M 29S 2H 38M 53S
2H 36M 36S
FIRST PENUBRAL CONTACT(P1)
+k to l
2H 36M 36S 1H 6M 3S
3H 42M 39S
FIRST UMBRAL CONTACT(U1)
+l to r
3H 42M 39S 1H 32M 23S
4H 74M 62S
GEOCENTRIC CONJUCTION
+r to m
4H 74M 62S 0H 1M 13.9S
5H 16M 16S
GREATEST ECLIPSE
+m to p (mn + np)
5H 16M 16S 0H 4M 55S 1H 31M 8.8S
6H 52M 19.8S
LAST UMBRAL CONTACT(U4)
+p to q
6H 52M 19.8S 1H 7M 44S
8H 0M 3.8S
LAST PENUBRAL CONTACT(P4)
©IJRASET: All Rights are Reserved
1154
International Journal for Research in Applied Science & Engineering Technology (IJRASET) ISSN: 2321-9653; IC Value: 45.98; SJ Impact Factor: 7.429 Volume 8 Issue V May 2020- Available at www.ijraset.com
B. Comparison Contact Points
Calculated
FIRST PENUBRAL CONTACT(P1) LAST PENUBRAL CONTACT(P4) FIRST UMBRAL CONTACT(U1) LAST UMBRAL CONTACT(U4)
2H 36M 36S
According to NASA’s Eclipse page 2H 29M 43.5S
8H 0M 3.8S 3H 42M 39S 6H 52M 19.8S
8H 5M 36S 3H 34M 24.2S 7H 00M 53.6S
©IJRASET: All Rights are Reserved
1155
International Journal for Research in Applied Science & Engineering Technology (IJRASET) ISSN: 2321-9653; IC Value: 45.98; SJ Impact Factor: 7.429 Volume 8 Issue V May 2020- Available at www.ijraset.com VII. CONCLUSION A. The experiment for the determination of values of Penumbra and Umbra has been successfully carried out. B. The results of the experiment performed by geometrical method are in good agreement with the data which are published on website of NASA. VIII. ACKNOWLEDGMENTS I am highly thankful to my project guide professor B.Y. Thakor, P.G. department of physics, Vallabh Vidhyanagar for providing me necessary guidance and help towards the successful completion of the project. He was always helpful throughout my project and guided me about ways to analyze problems. I am grateful to him for giving me an opportunity to learn something in astronomy during my final year. My thank are also due to professor P.C Vinodkumar, Head of physics P.G. department, Sardar Patel university, Vallabh Vidhyanagar for assigning project work in the final year. Last but not the least I would like to thank all those who helped me directly or indirectly in completion of my project. REFERENCES [1] [2]
Fred Espenak, NASA’s GSFC Prof. Brijmohan Y Thakor – P.G.Department of Physics, Vallabh Vidhyanagar
©IJRASET: All Rights are Reserved
1156