Design Guidelines
A Development by: Walton Development and Management 295 West Crossville Road Building 700, Suite 170 Roswell, Georgia 30075 P: 770.642.7750
Civil Engineer: Paulson Mitchell, Incorporated 85-A Mill Street, Suite 200 Roswell, Georgia 30075 P: 770.650.7685
Development to comply with the Zoning Resolution of Fulton County and the Sandtown Overlay District
Woodbury Design Guidelines Fulton County, Georgia
Design Guidelines Site Architecture Signage
These guidelines are the property of Randall-Paulson Architects, Incorporated. These documents may not be copied, reproduced, used or implemented in any way, in part or in whole, without written consent of Randall-Paulson Architects, Incorporated. All common law rights of copyright are hereby specifically reserved.
June 28, 2016
Table of Contents
1. Introduction
2. Site
3. Architecture
4. Signage
1.1 Table of Contents
2.1 Site Plan
3.1 Building Elements
4.1 Signage
1.2 Design Objectives
2.2 Typical Street Sections
3.2 Building Services
1.3 Project Description Maps
2.3 Landscape Details General Intent Landscaping at Entries Landscaping Features Trail System 2.4 Pedestrian Amenities Hardscape Patios Low Walls Furnishings 2.5 Site Lighting Street Lighting Pedestrian Lighting Parking Area Lighting Accent Lighting
Design Guidelines
Site
Architecture
Signage
1.1
June 28, 2016
Design Objectives
Woodbury Design Guideline Objectives The objective of these Design Guidelines is to create a recognizable identity for Woodbury and the surrounding areas. The development of a retail center, retail pads, light industrial sites, offices and restaurants will be done in a consistent architectural character described by these guidelines. This character will be expressed through the building materials, building scale, landscaping, hardscaping, pedestrian amenities, signage and site planning. The theme of Woodbury will that be of a transitional architecture blending modern architecture with traditional elements. Woodbury will use indigenous/native landscape materials and features including substantial preservation of areas along the creek. Pedestrian circulation is encouraged through planting, walkways, site furniture and site lighting.
Design Guidelines Site Architecture Signage
1.2
June 28, 2016
Project Description
Maps Woodbury is located in Fulton County, Georgia, between Fulton Industrial Boulevard, Riverside Drive SW and Campbellton Road SW. Areas to the south are residential neighborhoods. The areas to the west and north are light industrial and to the east commercial and residential neighborhoods. Woodbury to provide opportunities for office, commercial, research facilities, light industrial, retail, restaurant and multifamily, interconnected in a campus-like setting.
Ri ve rsi d
eD
riv e
Fu lto n
In du str
ia l
Bl vd .
Location
Site Plan
Design Guidelines Site Architecture Signage
1.3 4
June 28, 2016
Site
Site Plan Landscaping Pedestrian Amenities Site Lighting
Design Guidelines
Site Architecture Signage
52
June 28, 2016
Site
Site Plan This is a conceptual layout and is to be used for reference only. The actual site plan may differ at the discretion of the developer as the market dictates.
Site Plan
Enlarged Office Area
Design Guidelines
Site Architecture Signage
Enlarged West Retail Area
Enlarged Residential & Retail Area
2.1 6
June 28, 2016
Typical Street Sections
Street Sections A and B
Type A
82’ Wide
Type B 80’ Wide
Design Guidelines
Site Architecture Signage
2.2.1 11
June 28, 2016
Typical Street Sections
Street Sections C and D
Type C
58’ Wide
Type D 51’ Wide
Design Guidelines
Site Architecture Signage
2.2.2 12
June 28, 2016
Typical Street Sections
Street Sections E and F
Type E
46’ Wide
Type F 41’ Wide
Design Guidelines
Site Architecture Signage
2.2.3 13
June 28, 2016
Typical Street Sections
Street Sections G and H
Type G
35’ Wide
Type H 20’ Wide
Design Guidelines
Site Architecture Signage
2.2.4 14
June 28, 2016
Landscape Details
General Intent Landscaping will define spaces, provide dramatic views to those spaces, enhance a feeling of arrival and promote the notion of a community for visitors and workers. Service areas shall be screened with evergreen trees and shrubs, if no screen wall is present.
Design Guidelines
Site Architecture Signage
2.3 7
June 28, 2016
Landscape Details
Conceptual Entry at Residential Neighborhood
Conceptual Entry at Retail Pad
Conceptual Entry at Retail Center
Conceptual Entry at Industrial Site
Design Guidelines
Landscaping at Entries Entrances to sites to have a space for a monument sign that is clearly visible. Areas around this sign to receive decorative bushes and flower beds.
Site Architecture Signage
2.3.1 8
June 28, 2016
Landscape Details
Conceptual Retail Entry at Fulton Industrial Blvd.
Design Guidelines
Conceptual Corporate Entry at Fulton Industrial Blvd.
Site Architecture Signage
Landscaping at Entries Entrances to sites to have a space for a monument sign that is clearly visible. Areas around this sign to receive decorative bushes and flower beds.
2.3.2 9
June 28, 2016
Office and Retail Buildings
Major traffic routes will be indicated by a different tree species than in parking aisles. Trees shall be planted along walkways to provide shade. Parking shall be provided in various forms including on street parallel and 60• in island parking. Parking lots shall be located withing the interior limits of the development and broken into a small scale by walkways and landscaping.
Retail Plaza
Major traffic routes will be indicated by a different tree species than in parking aisles.
Residential Areas
Trees to be provided along the streets and access roads. Parking areas to be within limits of residential development and be provided with walkways and landscaping islands with trees.
Light Industrial Sites
Loading and service areas to be screened with evergreen trees and shrubs. Visitor parking area to be provided that include islands with trees.
Green Areas
Green areas shall be planted with shrubs, trees and grass to convey a small-town urban park or square. Formal designs with specimen trees, low hedges and parterres are acceptable when near village scale architecture. Less formal and more ‘park-like’ arrangements are better suited when the green space is more distant from buildings. Juxtaposition of deciduous and evergreen trees to provide landscape contrast is encouraged. Site furniture and paved pedestrian access is encouraged, if the space is large enough. These areas shall be well lighted for security and aesthetics. Accent lighting is also encouraged to promote outdoor use of those areas in close proximity to outdoor vendors.
Landscape Details
Landscaping Features
Perimeter Landscape
Rhythm, function and scale are the important characteristics of this area. Trees, evergreen trees, understory trees, shrubs and groundcover all shall be used to provide these characteristics. Views into the commercial areas shall be provided in order for traffic to see activity and buildings. Building service and utility areas shall be screened. Locate shade trees, understory trees and low-medium shrubs in the areas with views into the commercial areas. High canopy and low shrubs minimize obstructions. Design of this area must consider the relationship to architecture, function of plant material as well as safety and security. Where landscaping is adjacent to a residential area, the scale and context of the neighborhood shall be taken into consideration.
Parks and Preservation Area
Areas to be left undisturbed except by paved trails with occasional benches. Entrances to trails to have maps, garbage bins and dog waste stations.
Boulevard Landscape
Boulevards are broad tree-lined streets to access commercial, industrial, and residential areas. Tree spacing standard shall be consistent between 35 and 45 feet.
Design Guidelines
Site Architecture Signage
2.3.3 10
June 28, 2016
Preservation Area Areas along the creeks will be dedicated to common open spaces. These areas are to be used for recreation, stormwater management and preservation purposes.
Design Guidelines
A trail system is to be built along preservation areas. Trails and paths to connect all preservation areas and parks.
Site Architecture Signage
Trail System
2.3.4 19
June 28, 2016
Pedestrian Amenities
Street Types A and B
Retail Center
Trails
Sidewalks shall be 6’ wide, broom finish with smooth troweled joints every 5’.
Sidewalks adjacent to buildings shall be a minimum of 5’ in width.
Trails shall be paved with asphalt or concrete broom finish.
Edge of sidewalk to be 5’ from face of curb.
Accent pavers may be brick or concrete.
Path to be a minimum 5 feet wide.
Hardscape
Curb ramps to have a textured surface Crosswalks shall be clearly delineated from the street and may have stamped concrete or brick pavers.
Design Guidelines
Concrete joints shall relate to architectural elements, i.e. columns, façade joints etc.
Site Architecture Signage
2.4.1 15
June 28, 2016
Pedestrian Amenities
Patios
Low Walls
Patios or low walls shall be consistent in design with this section. Patios provide intimate spaces for dining and people gathering. Patios may be open or separated from the sidewalk and street by low walls, landscaping, or fencing. Patios shall not extend to the curb. Ample space should be provided beyond patio for pedestrians, sidewalk furniture and/or landscaping between edge of patio and street curb. Patios may be covered by awnings that are attached to the building facade.
Low walls may be used to separate patio and landscaped areas from pedestrian circulation. They shall be constructed from either brick with a precast cap or a combination of brick piers and/or fencing and be compatible in appearance with nearby buildings and landscaping.
Design Guidelines
Patios Low Walls
They may be adjacent to sidewalks and provide additional seating space or lined with landscaped beds.
Site Architecture Signage
2.4.2 16
June 28, 2016
Pedestrian Amenities
Beaches and Seating
Benches encourage pedestrian activity and provide for a place of rest. Benches may be of a dark green or black metal or a metal/wood finish. Fixing benches to the ground or sidewalk is encouraged. The above photos are examples of appropriate seating fixtures.
Design Guidelines
Trash Receptacles
Trash receptacles are to be of sturdy metal construction. Finishes shall be dark green or black to match other street furniture and lighting fixtures. They shall not impede pedestrian traffic and are encouraged to be secured to the ground or sidewalk.
Site Architecture Signage
Dog Waste Stations
Furnishings
Dog waste stations to be provided at main entrances to trails.
2.4.3 17
June 28, 2016
Site Lighting
Street Lighting
Street lights are to illuminate roads and boulevards. Fixture height to be 40 feet maximum, color black cobra head type, full cutoff. Spacing to be 150 ft on center.
Pedestrian Lighting
Pedestrian sidewalk lights are used to light sidewalks and patio areas in front of retail and office areas. Finish to be black. When located along streets, light pole to be located within the planting and furniture strip. Maximum fixture height is 15 feet.
Street Lighting Pedestrian Lighting Park Area Lighting Accent Lighting
Retail Center Parking Area Lighting
Light fixtures intended to illuminate parking area for tenants and customers. Fixture height to be 35 feet maximum, color black, box head type, full cutoff.
Design Guidelines
Accent Lighting
Accent lighting is used to light planted areas, signage, and water features. Accent lights may be up-lights mounted in ground or above ground. If mounted above ground, the lights shall have a dark finish to match pedestrian sidewalk lights.
Site Architecture Signage
2.5 18
June 28, 2016
Building Elements - Commercial
Building Features
The architecture shall reflect a blend of traditional and contemporary elements. Durable materials should be used.
Pedestrian Scale Elements
Porches, awnings, canopies, should be used when possible to create a sense of pedestrian scale. Decorative light fixtures at facades are also encouraged.
Design Guidelines
Design Elements
Materials, colors and texture shall provide visual interest to the buildings. Reveals, wall offsets, pilasters are encouraged to break up large flat surfaces.
Building Elements - Commercial
Architecture to comply with the Zoning Resolution of Fulton County and the Sandtown Overlay District, Article XIIF.
Railings and Low Walls
Any railings and fences may be used to aid pedestrians, to define spaces such as patios, or to protect planted areas. They also may be used to add a decorative element to the streetscape. Any metal fencing shall be painted dark bronze or black and may be used in combination with brickwork.
Site Architecture Signage
3.1 20
June 28, 2016
Building Elements - Residential
Building Features
The architecture shall be traditional with contemporary elements. Durable materials should be used. Facades to provide visual interest and texture to the building. Material transition to occur at inside corners, never at or close to an outside corner.
Pedestrian Scale Elements
Porches, stoops and balconies should be used to create a sense of pedestrian scale. Facades to be no more than 20’ from sidewalk
Design Guidelines
Design Elements
Single window width not to exceed 1/2 of the height. If muntins are used, width to be no more than 1� and be flush with window frame on the exterior. No snap-ons or inside glass muntins are allowed. No storefront window frames are allowed. Railings to be wood, synthetic or powder coated metal.
Building Elements - Residential
Architecture to comply with the Zoning Resolution of Fulton County and the Sandtown Overlay District, Article XIIF.
Garages
Garages should be accessed from the back of the lot for at least 75% of units. When garage doors face the front of the lot, it should not take more of 50% of the garage length.
Site Architecture Signage
3.1.1 21
June 28, 2016
Building Elements - Industrial
Building Features
Facades seen from street or public driveways to have a variation in parapet height and color or materials. Entrances to be clearly marked with a canopy and landscaping.
Design Guidelines
Site Architecture Signage
Building Elements - Industrial
Architecture to comply with the Zoning Resolution of Fulton County and the Sandtown Overlay District, Article XIIF.
3.1.2 24
June 28, 2016
Building Elements - Industrial
Design Elements
Materials, colors and texture shall provide visual interest. To the buildings. Reveals, wall offsets, shading devices, and pilasters are encouraged to break up large flat surfaces. At least 15% of wall area visible from street to receive windows.
Design Guidelines
Site Architecture Signage
Building Elements - Industrial
Architecture to comply with the Zoning Resolution of Fulton County and the Sandtown Overlay District, Article XIIF.
3.1.3 25
June 28, 2016
Building Services
Transformers
Roof Top Equipment
Dumpster Enclosure
Loading Areas
Transformers to be screened by landscaping or be located in areas not visible by the public.
Dumpster enclosures to be done with durable materials and be provided with gates.
Design Guidelines
Parapets to be equal or higher than top of roof top equipment at public areas.
Building Services All service equipment to be screened from public view.
Loading areas to be screened by proper placement and scaling of landscaping or by a screen wall that complements the building.
Site Architecture Signage
3.2 22
June 28, 2016
Signage
Monument Signs
District Signs
Street Signs
Stop Signs
Monument signs to be consistent with the architecture of the business. It may include name of the center, address and various tenants.
Street signs to be consistent throughout Woodbury and be clearly legible. Reflective letters shall be used for improved night visibility.
Design Guidelines
Site
Architecture
Located at the entrance of each district, these signs to set the character of the community and to be used as wayfinding. Location to provide good visibility for vehicles and pedestrians.
Signage
Stop signs to be consistent with the street signs throughout Woodbury and be clearly legible. Reflective letters shall be used for improved night visibility.
Signage
4.1 23
June 28, 2016