EPSON INK PAD REPLACEMENT KIT INSTALLATION INSTRUCTIONS VISIT DECOPAC.COM FOR PHOTOCAKE PRINTER MAINTENANCE VIDEOS Available to specific Epson printers: XP-410
XP-420
XP-430
XP-340
XP-352
XP-452
XP-440
XP-446 XP-2100
Before you start: • Instructions shown are for PhotoCake IV 8.XX version • Specific instructions for PhotoCake Online and PhotoCake IV 9.XX versions can be found on our website. • Must be on Update 42 or newer
DIRECTIONS
1 From the printer menu, navigate to “Setup”; select “Maintenance”.
• For the XP-2100: Open the lid to the printer, then press and hold the Cancel button for 10 seconds.
2 Select “Ink Cartridge Replacement” and remove ink cartridges.
• For the XP-2100: Carriage will move to the right, remove inks
3 Power off the printer. Disconnect Power and USB cables from printer. 4 Remove extended output tray. Push in Paper Feed and connected Output trays. 5 Set Printer display side down so rear of printer is facing up. 6 Using the #2 screwdriver (included in kit), remove screw and set aside. 7 Slide the Ink Pad tray to the right and remove. 8 Install new Ink Pad, reinsert screw. 9 Set printer right side up, reconnect trays and cables. 10 Power printer on and install ink cartridges. 11 O n PhotoCake System Screen, enter in the 12-digit Reset Code. Select 'Enter'. 12 F ollow PhotoCake System Screen prompt to power off printer, select
PHOTOCAKE EPSON INK PAD REPLACEMENT KIT #27221 – Each
'Ok' and then power printer back on.
5 S et printer
display side down
6 R emove screw and
slide ink pad to right
7 S lide the Ink Pad tray to right and remove
8 I nsert new ink pad
and reinsert screw
11 E nter Reset Code
(located on front of box and on bottom of ink pad)