INSTALLATION GUIDE 83 ¾"
1. PREPARATION
34½"
ch & tagline Myriad pro Regular
You must locate the high point in the floor where the cabinets will be installed. Please refer to local building codes before installation.
24 "
Fig. 1a
From this high point, measure up the wall and mark the top line of your base cabinets (34½") and the top line of your wall cabinets 83¾" if using 30"H wall cabinets, or 93¾" if using 40"H wall cabinets. (Fig. 1a) Mark the outline of all cabinets on the wall to confirm cabinet fit.
" 24
W3615-24 W3615-24 W1530
W2130
W1530 WA2430 W2430
W3630
UP1884 BE33
Using a stud finder, locate the wall studs. Mark the centre of the wall studs at the top and bottom of the wall cabinet position. Most wall studs are located 16" apart. (Fig. 1b)
Stove BH15
BH15 Dishwasher
Fridge BH36
BH21
SB36
Fig. 1b 2. INSTALLING WALL CABINETS Start with the corner wall cabinet. Pre-drill the cabinet top and bottom rail to line up with the wall studs. Fasten the corner cabinet loosely to the wall with 3" wood screws. Shim the cabinet to make it level and plumb. When the cabinet is perfectly plumb and level, tighten the screws. (Fig. 2a) If you are using a Blind Corner Wall Cabinet, be sure to pull it out from the corner the distance indicated on your floor plan drawing.
Shim
Fig. 2a
Shim
Blind Corner Wall Cabinet
Regular Wall Cabinet
Filler
To turn the corner from the installed Blind Corner Wall Cabinet, attach a filler strip trimmed to fit using 1½" screws to the side of the adjacent cabinet. Screw from the inside of the cabinet, and into the filler strip. (Fig. 2b) Continuing by installing adjacent wall cabinets. Pre-drill the back of the adjoining cabinet through the hanging rails to line up with the wall studs.
Fig. 2b
Position the adjoining cabinet so that the front edges of both cabinets are flush, using shims if necessary. Cabinets should always be plumb and level. Attach loosely to the wall, and attach the cabinets together using clamps. Pre-drill four 1/8" diameter holes through one cabinet in the locations shown in the diagram. Do NOT penetrate the adjoining cabinet! Secure the cabinets together using 1-1/8" flathead screws and cup washers (not supplied). (Fig. 2c) Finish by tightening the cabinet securely to the wall. Continue until all wall cabinets are installed. *Blu-motion Soft Close Notice: 40" high doors require 2 soft close per door.
Fig. 2c
Flush