Form No. MSC06590 Rev B
Back Drag Edge Kit V-Blade Plows Part No. MSC06584 Part No. MSC06585 Part No. MSC06586 Part No. MSC29080
Installation Instructions
Safety
may need to weigh the vehicle and add ballast or limit the payload of the vehicle to compensate.
Installing this kit changes the weight of your plow. Ensure that your vehicle does not exceed the gross-vehicle-weight rating (GVWR) at any time. You 1.
Park the machine on a level surface and raise the plow a few inches off the ground.
2.
Place a jack stand under the plow pushframe, shut off the vehicle engine, engage the parking brake, and remove the key.
3.
Remove the bolts, washers, and nuts that secure the cutting edge to the plow and discard them (Figure 1). Retain the cutting edge.
g247196
Figure 2 1. Bolt 2. Cutting edge
4. Washer 5. Nut
3. Back drag edge
g247195
Figure 1 1. Hardware—discard
4.
2. Cutting edge—retain
Install the back drag edge and previously removed cutting edge to the plow using new bolts, washers, and nuts (Figure 2).
© 2024—BOSS Products 2010 The BOSS Way Iron Mountain, MI 49801
Register at www.bossplow.com.
Original Instructions (EN) Printed in the USA All Rights Reserved
*MSC06590*